Use your blender for soups, sauces,
drinks, pâtés, mayonnaise, dressings
etc.
before using your Kenwood
appliance
●Read these instructions carefully and
retain for future reference.
●Remove all packaging and any
labels.
safety
●Allow all liquids to cool to room
temperature before placing them in
the blender.
●Switch off and unplug:
●●before fitting or removing parts
●●after use
●●before cleaning.
●Keep hands and utensils out of the
blender when it’s on the power unit.
●Don’t touch the sharp blades.
●Never let the power unit, cord or
plug get wet.
●Never use a damaged machine. Get
it checked or repaired: see ‘service’.
●Never use an unauthorised
attachment.
●Never leave the machine on
unattended.
●When removing the blender from the
power unit:
●●wait until the blades have
completely stopped;
●●don’t accidentally unscrew the
goblet from the blade unit.
●Never run the blender empty.
●Always unplug your blender
when not in use.
●Only operate the blender with the lid
in place.
●Important - The skirt on the base
of the goblet is fitted during
manufacture and no attempt should
be made to remove it.
●Misuse of your blender can result in
injury.
●This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
●Children should be supervised to
ensure that they do not play with the
appliance.
●Only use the appliance for its intended
domestic use. Kenwood will not accept
any liability if the appliance is subject to
improper use, or failure to comply with
these instructions.
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of the machine.
Important – UK only
●The wires in the cord are coloured
as follows:
Blue = Neutral,
Brown = Live.
●The appliance must be protected by
a 3A approved (BS1362) fuse.
Note:
●For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
●If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
●This appliance conforms to EC
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
2
