Kenwood KFC98W User manual

Instruction Manual
Please read it carefully and keep for future reference.
Two Door Refrigerator
KFC98W
Kenwood

8
Maintenance
5---7
Food storage
9---10
Trouble Shooting
CONTENT
2
Parts
1
Safety Precaution
3
Placement
Operation check 4
FOLLOWING PHENOMENON IS NORMALFOLLOWING PHENOMENON IS NORMAL
The sound like a rivulet is caused by the refrigerant flowing inside of the
system pipe.
While the unit runs, heat is emitted from both sides of the cabinet.
When the environment is too humid, the edges around door may have a
little moisture, wipe it with a dry cloth.
CHANGE THE LIGHT BULBCHANGE THE LIGHT BULB
Before changing the light bulb, please unplug the refrigerator first,
then pull down the light cover and change the light bulb according to the
picture . Make sure the light bulb is 220-240V~/50Hz/10W.
TROUBLE SHOOTING
10
Light cover
Pull down

Before asking for repair service, please check the following
issues first:
Trouble Possibility
The unit
doesn't
work
Power has not been supplied, or the plug is too loose
to fit in the socket.
Low voltage
The control knob is set at OFF
The unit
works
inefficiently
The control knob is set at a low number position
Too much food in the unit
Hot food in the unit
Door opened & closed too frequently
There is a heat source nearby
The unit is exposed to direct sunlight
Noise
Floor is not flat, and the unit is not placed steadily.
Components are not placed in the right position
Food frozen Is the control knob set at proper position?
The reason of the trouble
TROUBLE SHOOTING
9

SAFETY PRECAUTION
¾Æ¾«
¾Æ¾«
Please always follow the safety hint listed below:Please always follow the safety hint below:listed
Please unplug the unit first when you
replace the light bulb or repair the
refrigerator.
Hanging or seating on the door is very
dangerous, it may turn over the unit.
capability may be
as the electrical insulation
weakened.
Please don't splash water on the cabinet,
1
The power supply for the unit should be
exactly the same as described on the data
sheet, and use the standard socket which
must be well grounded.
erosive volatility goods into cabinet.
The unit should be operated in the absence
of flammable or explosive fumes. It is
prohibited to put the flammable, acid or
Please unplug the unit immediately if you
find anyabnormal smell or smoke, and contact
the service center.
CLEANINGCLEANING
Always unplug the unit before cleaning.Always unplug the unit before cleaning.
LEAVING THE UNIT SWITCHED OFFLEAVING THE UNIT SWITCHED OFF
If the unit will be switched off for a long
time, the plug should be pulled out, then
clean the unit thoroughly. Ensure that the
door cannot be fully closed (leave a suitable
gap), and place the unit in a well-ventilated
area to avoid any odor.
The unit should be cleaned frequently both
inside and outside using water and a
little neutral detergent. Never use boiling
water,harsh cleaning agents,acid, alkali or
benzene etc.
MAINTENANCE
8
Located at the back of the cabinet, the water pan
is designed to collect and evaporate the defrosted
water. It needs cleaning each half year.
Before cleaning, you need lift it upper a little then
draw it out horizontally. After cleaning, refix it to
the original position. Make sure the fastner is fixed
exactly with the back cover.
SAFETY PRECAUTION
¾Æ¾«
¾Æ¾«
Please always follow the safety hint listed below:Please always follow the safety hint below:listed
Please unplug the unit first when you
replace the light bulb or repair the
refrigerator.
Hanging or seating on the door is very
dangerous, it may turn over the unit.
capability may be
as the electrical insulation
weakened.
Please don't splash water on the cabinet,
1
The power supply for the unit should be
exactly the same as described on the data
sheet, and use the standard socket which
must be well grounded.
erosive volatility goods into cabinet.
The unit should be operated in the absence
of flammable or explosive fumes. It is
prohibited to put the flammable, acid or
Please unplug the unit immediately if you
find anyabnormal smell or smoke, and contact
the service center.
CLEANINGCLEANING
Always unplug the unit before cleaning.Always unplug the unit before cleaning.
LEAVING THE UNIT SWITCHED OFFLEAVING THE UNIT SWITCHED OFF
If the unit will be switched off for a long
time, the plug should be pulled out, then
clean the unit thoroughly. Ensure that the
door cannot be fully closed (leave a suitable
gap), and place the unit in a well-ventilated
area to avoid any odor.
The unit should be cleaned frequently both
inside and outside using water and a
little neutral detergent. Never use boiling
water,harsh cleaning agents,acid, alkali or
benzene etc.
MAINTENANCE
8
Located at the back of the cabinet, the water pan
is designed to collect and evaporate the defrosted
water. It needs cleaning each half year.
Before cleaning, you need lift it upper a little then
draw it out horizontally. After cleaning, refix it to
the original position. Make sure the fastner is fixed
exactly with the back cover.
SAFETY PRECAUTION
¾Æ¾«
¾Æ¾«
Please always follow the safety hint listed below:Please always follow the safety hint below:listed
Please unplug the unit first when you
replace the light bulb or repair the
refrigerator.
Hanging or seating on the door is very
dangerous, it may turn over the unit.
capability may be
as the electrical insulation
weakened.
Please don't splash water on the cabinet,
1
The power supply for the unit should be
exactly the same as described on the data
sheet, and use the standard socket which
must be well grounded.
erosive volatility goods into cabinet.
The unit should be operated in the absence
of flammable or explosive fumes. It is
prohibited to put the flammable, acid or
Please unplug the unit immediately if you
find anyabnormal smell or smoke, and contact
the service center.
CLEANINGCLEANING
Always unplug the unit before cleaning.Always unplug the unit before cleaning.
LEAVING THE UNIT SWITCHED OFFLEAVING THE UNIT SWITCHED OFF
If the unit will be switched off for a long
time, the plug should be pulled out, then
clean the unit thoroughly. Ensure that the
door cannot be fully closed (leave a suitable
gap), and place the unit in a well-ventilated
area to avoid any odor.
The unit should be cleaned frequently both
inside and outside using water and a
little neutral detergent. Never use boiling
water,harsh cleaning agents,acid, alkali or
benzene etc.
MAINTENANCE
8
Located at the back of the cabinet, the water pan
is designed to collect and evaporate the defrosted
water. It needs cleaning each half year.
Before cleaning, you need lift it upper a little then
draw it out horizontally. After cleaning, refix it to
the original position. Make sure the fastner is fixed
exactly with the back cover.
Cleaning the water panCleaning the water pan
WARNING:
- Do not freeze fizzy drinks.
- Warning to customers about delay start allow gases to settle.
- Use limited to 16-32 Deg.C.
- Do not put hot products into the appliance, allow to cool before freezing.

PART S
2
FOOD STORAGE
7
ice cubes. Fill the cold drinkable water to
a height of four-fifth of the ice tray, and
place it in the freezer for 2 hours.
When the cubes are fully frozen, take the
ice tray out and twist it back and forth to
separate the ice cubes. Don't over-bend
the ice tray to avoid breaking it.
The usage of theice tray is to make
ICE TRAYICE TRAY
Use it to store food that need to freeze.
The big block meat should be separated into
small block before store, it will be convenient
for your cooking later. Lift forward, then
upward slightly, you can take out the drawer.
FREEZER COMPARTMENT DRAWERFREEZER COMPARTMENT DRAWER
Frozen food should be classified to store
in order to find them easily and saving the
energy.
2
For the product improvement, the refrigerator that you purchased may have a little
difference from this specification.
4
8
Freezer drawer pan
Door pan low
1
5
9
Control housing
Power plug
Door pan
3
7
Crisper
Leg leveler
2
6
1010
Shelf
Kick plate
Egg tray cover