KERN SFB-A01 User manual

KERN & Sohn GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: [email protected]
Tel: +49-[0]7433- 9933-0
Fax: +49-[0]7433-9933-149
Internet: www.kern-sohn.com
Assembly instructions Tripod
KERN SFB-A01
Version 1.0
11/2012
GB
SFB-A01-IA-e-1210

SFB-A01-IA-e-1210 2
GB
KERN SFB-A01
Version 1.0 11/2012
Assembly instructions Tripod
Contents
1Technical data..........................................................................................................2
2Scope of delivery .....................................................................................................3
3Assembly..................................................................................................................3
3.1 Assemble the tripod to the balance..................................................................................3
3.2 Assemble the display unit to the tripod............................................................................4
Tripod SFB-A01 only suitable for the following SFB-models:
SFB 60K2XLM
SFB 100K2L
SFB 100K2LM
SFB 100K2XL
SFB 100K2XLM
SFB 200K 2XL
SFB 300K1LM
1 Technical data
Tripod height
60 cm
Net weight
1800 g

3 SFB-A01-IA-e-1210
2 Scope of delivery
1. Tripod foot
2. Adapter display unit
3. Screws with securing disks and
washers
4. Tripod tube
3 Assembly
3.1 Assemble the tripod to the balance
Attach the tripod to the platform acc. to
illustration using the 4 screws [1],
securing disks and washers.
(Ensure that the cable is not damaged
nor squeezed.)
Screw-out support screw [2] till it is safely
fixed.

SFB-A01-IA-e-1210 4
Unscrew the screws [3] from the tripod
foot.
Introduce the tripod tube [4] into the
tripod foot until the hole in the tripod tube
and the hole in the tripod foot are exactly
one above the other.
Screw-in the screw [3] again.
Fix the tripod tube using screws [5].
3.2 Assemble the display unit to the tripod
Screw tight the adapter [6] of the display
unit to the display unit using 4 screws [7]
according to the illustration.
Ensure that the screw of the adapter is
on the same side as the hole in the
tripod tube.
Use the screw of the adapter to fix the
display unit on the tripod.
Fix the cable using cable ties in a way
that it does not disturb the weighing
process.