KettenMax Premium User manual

Instruction manual KettenMax Premium
1. Preparation
Turn off the engine, select neutral and jack up the bike on the centre stand or paddock stand.
2a. Set up
Measure the chain width with template, select the correct brushes according to the template colour and put them
into the KettenMax (bottom box).
2b. Set up
Assemble the top and bottom box over the chain at an easy accessible point and lock with the rubber band.
Then screw the drain bag onto the KettenMax (bottom box).

2c. Set up
It is ideal to anchor the unit at the front and at the rear, and adjust with the quick release fasteners. Rotation is
possible in both directions.
The unit can be anchored at the front or rear only but rotation is only possible in one direction.
3. Cleaning
Attach the screw cap with nozzle to the bottle of cleaner, then using the hoses and Y-distributor, connect it to
the KettenMax unit.
Always connect the hoses to the upper (chain ingoing side) and bottom nozzle connection of the KettenMax.
With change of rotation direction, reverse the upper hose.
Supply cleaner proportionally while rotating the rear wheel slowly (2 x chain run per minute). A gentle overall
cleaning of the chain is ensured.

4. Lubricating
Before lubricating, unscrew the cleaner bottle and close with the original cap. Disconnect the hoses from the
KettenMax. Let the chain dry for about 3 to 5 minutes.
Put the lubricating adaptor on the upper nozzle connection on the KettenMax (chain outgoing side). Spray in
the lubricant in steps. Rotate the rear wheel slowly (2 x chain runs per minute). The lubricant accurately coats
the important inner side of the chain and is evenly distributed by brushes.
!