Kewtech KTP1 User manual

KTP1
Proving Unit
kewtechcorp.com
Instruction Manual

Safety - KTP1 Proving unit
•This product is designed for use by a competent person with
appropriate training and with non-contact voltage testers such
as the KEWSTICK UNO and KEWSTICK DUO.
•Do not use the proving unit if there are any signs of cracks or
other damage – to clean use only a dry cloth.
•This product is only intended to prove the function of
non-contact voltage testers, it must not be used in any other
non-intended way.
•When installing the battery observe the correct polarity as
indicated inside the battery compartment. Do not force the
battery, the compartment is designed to take the battery only
one way.
•The proving unit does not have any user serviceable parts –
do not attempt to dismantle.
Product features:
•Portable proving unit for use on / off site
•Instantly proves the function of
non-contact voltage testers before
and after use.
•Simple to use just press the button
and test
•Belt clip for hands free use
•Visual LED indication of function
•Robust and drop proof from 1 metre

Instructions for use:
The proving unit comes installed with a 9V battery. Remember to
remove the plastic keeper tag sticking out of the battery compartment
by pulling it out.
Have your non-contact voltage tester to hand.
Depress the start auto test button and release. This activates the
proving unit for approximately 5 seconds. The blue LED will indicate the
proving unit is active.
During this 5 seconds hold your non-contact tester tip across the yellow
test point area to prove function.
You do not have to keep the button pressed in. Simply press again to
re-activate for another 5 seconds.
When the blue LED becomes dull then the battery requires
replacement.* Open the battery compartment by using a 6mm flat
bladed screwdriver to turn the lock one quarter turn anti-clockwise as
indicated, and remove the cover. Replace the battery and observe the
correct polarity.
Replace the battery cover and close by turning the lock one quarter
turn clockwise with the same screwdriver.
*N.B – The proving unit is designed to use very little current to enable it to perform many
thousands of tests on a single cell. We recommend battery replacement annually in case of any
leakage. Please observe correct disposal and re-cycling legislation and do not dispose of the
battery in normal refuse.

Specifications:
•Safety – complies with BSEN 61010-1:2010
•Double insulated
•Output – electric field to simulate 230V AC
•Operating temperature -10 to 50°C
•Humidity max 90%
•Batteries – requires 1 x 9V IEC-6F22
Kewtech Corporation Limited
T: 01494 792 212 F: 01494 791 826
E: [email protected]
kewtechcorp.com
Belt clip
Battery
compartment
lock