1 - ATTENTION
The digital selector SEL-R/SEL-F works like a 12 digits transmitter and two channels, the-
refore all the programming and deletion functions of the codes are to be referred to the
receiver only (sold apart).
2 - CODE PROGRAMMING PROCEDURE
1) Select on the receiver the channel and the kind of function you want to use (please see
the manual of the receiver).
2) Within 6 seconds type a code of at least 4 numbers on the external digital keyboard and
then press < or >.
3) The red LED of the receiver will be lighted x on, that means that the code has been
memorized; if the LED of the receiver ash quickly, that means that this code was already
memorized.
4) To activate the control, type the code and then press < or >.
3 - DELETION OF A SINGLE CODE
Follow the receiver procedure. When it is required to push the transmitter button press
the 4 digits code and then < or >.
4 - DELETION OF ALL MEMORIZED CODES
Follow the receiver procedure.
TECHNICAL DATA SEL-R (rolling code) SEL-F (x code)
Supply 3 V 3 V
Frequency 433,92 MHz 433,92 MHz
Protection degree IP 55 IP 55
Transmission consumption 20 mA 20 mA
Channel number 2 2
Antenna incorporated incorporated
Estimated range 20 m (outside) 20 m (outside)
Operating temperature -10 +55 °C -10 +55 °C
Weight 160 g 160 g
