Keystone hardscapes Ashland User manual

ASHLAND™

ROUND FIRE PIT

ASHLAND

™

| ROUND FIRE PIT KIT

ASHLAND

™

| ROUND FIRE PIT KIT

Step 1 | Foundation

Place and compact a level base with gravel extended beyond the

Ashland ﬁre wedge units by at least 4 inches. The surface of the

leveling pad should extend below grade by 2 inches. If you are

using a concrete paver base, place Ashland units directly onto the

base. Fill the bottom with 2-4 inches of sand for drainage.

Step 2 | Install Base Course

Lay out the Ashland Fire Pit with a 32½" diameter from the inside

wall. Use 17 units per layer. Adjustments to the circle of units may

be necessary to ensure alignment as the unit should ﬁt tightly

together. Ensure the ﬁrst layer is level front-to-back and side-to-

side.

Step 3 | Install Additional Layers

Apply a bead of exterior grade construction adhesive to the base

layer of units. The second course units should be centered over

the two units below to establish a running bond (see graphic at

right).

Important Note: Burning large items or trash in ﬁre pits may cause damage to the Ashland units. Our ﬁre features are designed strictly for small ﬁres.

Keystone Hardscapes recommends a steel insert to protect units and will not be held liable for damage to the ﬁre pit or coping if an insert is not used.

Speciﬁcations

32½"

48½"

sand

compacted gravel or concrete

20½"

Installation

www.keystonehardscapes.com

Ashland Unit

4" x 9" x 8"

Optional 4-piece coping

(sold separately)