Keystone Hardscapes YORKSHIRE YSFPR User manual

YORKSHIRE™
RECTANGLE FIRE PIT
YORKSHIRE
™
| RECTANGLE FIRE PIT KIT

YORKSHIRE
™
| RECTANGLE FIRE PIT KIT
Step 1 | Foundation
Place and compact a level base with gravel extended beyond the Ashland fire
wedge units by at least 4 inches. The surface of the leveling pad should extend
below grade by 2 inches. If you are using a concrete paver base, place Yorkshire
units directly onto the base. Fill the bottom with 2-4 inches of sand for drainage.
Step 2 | Install Base Course
Lay out the first course (base layer) of Yorkshire units in a rectangle design with
28" x 28" from the inside wall. Use 14 units per layer. Adjustments to the units
may be necessary to ensure alignment as the units should fit tightly together.
Ensure the first layer is level front-to-back and side-to-side.
Step 3 | Install Additional Layers
Apply a bead of exterior grade construction adhesive to the base layer of
units. The second course units should be centered over the two units below to
establish a running bond (see graphic at right). Repeat for course 3. For the cap
course, place the units perpendicular to the previous courses to create a finished
layer that will overhang the courses below by 2" on each side.
Important Note: Burning large items or trash in fire pits may cause damage to the Yorkshire units. Our fire features are designed strictly for small fires.
Keystone Hardscapes recommends a steel insert to protect units and will not be held liable for damage to the fire pit or coping if an insert is not used.
Specifications
Installation
www.keystonehardscapes.com
©2021 The QUIKRETE Companies - KHS 01/2021
Yorkshire Unit
4" x 12" x 8"
Steel Insert
(with cooking grate)
Granite Blend
Desert Blend Sandstone Blend
Available Colors Optional Accessories
Steel Insert
Courses 1 & 3 Course 2
40"
56"
44"
Cap Course
Product Number #YSFPR
Included in Kit 63 Units
Length 56"
Width 44"
Height 16"
Pallet Weight 1,885 lbs
Running Bond
28"
Course below
*Product manufactured in Richmond, VA location only.