Keystone Hardscapes YORKSHIRE User manual

YORKSHIRE™
SQUARE FIRE PIT
YORKSHIRE
™
| SQUARE FIRE PIT KIT

Product Number #YSFP
Included in Kit 48 Units
Length 44"
Width 44"
Height 16"
Pallet Weight 1,142 lbs
YORKSHIRE
™
| SQUARE FIRE PIT KIT
Step 1 | Foundation
Place and compact a level base with gravel extended beyond the
Ashland fire wedge units by at least 4 inches. The surface of the leveling
pad should extend below grade by 2 inches. If you are using a concrete
paver base, place Yorkshire units directly onto the base. Fill the bottom
with 2-4 inches of sand for drainage.
Step 2 | Install Base Course
Lay out the first course (base layer) of Yorkshire units in a square design
with 28" x 28" from the inside wall. Adjustments to the units may be
necessary to ensure alignment as the units should fit tightly together.
Ensure the first layer is level front-to-back and side-to-side.
Step 3 | Install Additional Layers
Apply a bead of exterior grade construction adhesive to the base layer
of units. The second course units should be centered over the two units
below to establish a running bond (see graphic at right). Repeat for
courses 3 & 4.
Important Note: Burning large items or trash in fire pits may cause damage to the Yorkshire units. Our fire features are designed strictly for small fires.
Keystone Hardscapes recommends a steel insert to protect units and will not be held liable for damage to the fire pit or coping if an insert is not used.
Specifications
Installation
www.keystonehardscapes.com
©2021 The QUIKRETE Companies - KHS 01/2021
Yorkshire Unit
4" x 12" x 8"
Steel Insert
(with cooking grate)
Granite Blend
Desert Blend Sandstone Blend
Available Colors Optional Accessories
Steel Insert
Courses 1 & 3 Courses 2 & 4
28"
44"
44"
Running Bond
*Product manufactured in Richmond, VA location only.