STONELEDGE
™
| ROUND FIRE PIT KIT
Step 1 | Foundation
Place and compact a level base with gravel extended beyond the
StoneLedge fire pit by at least 4 inches. The surface of the leveling pad
should extend below grade by 2 inches. If you are using a concrete
paver base, place StoneLedge units directly onto the base. Fill the
bottom with 2-4 inches of sand for drainage.
Step 2 | Install Base Course
Lay out the StoneLedge Fire Pit with a 30" diameter from the inside
wall. Use 20 units per layer (13 medium & 7 small). Start each layer by
setting one medium unit. Then place one small unit followed by two
medium units in a repeating pattern. Adjustments to the circle of units
may be necessary to ensure alignment as the units should fit tightly
together. Ensure the first layer is level front-to-back and side-to-side.
Step 3 | Install Additional Layers
Apply a bead of exterior grade construction adhesive to the base layer
of units. The second course units should be centered over the two
units below to establish a running bond (see graphic at right).
Important Note: Burning large items or trash in fire pits may cause damage to the StoneLedge units. Our fire features are designed strictly for small fires.
Keystone Hardscapes recommends a steel insert to protect units and will not be held liable for damage to the fire pit or coping if an insert is not used.
Specifications
30"
50"
10"
10"
sand
compacted gravel or concrete
17½"
Installation
www.keystonehardscapes.com
©2021 The QUIKRETE Companies - KHS 04/2021
Medium Unit
3" x 9" x 10"
Optional 4-piece coping
(sold separately)
Steel Insert
(works with or without coping)
Available Colors Optional Accessories
Product Number #STOFP
Included in Kit 66 Medium & 36 Small units
Outside Diameter 50"
Inside Diameter 30"
Height 17½"
Pallet Weight 1,740 lbs
Running Bond
*Product manufactured in Richmond, VA location only.
Granite Blend
Desert Blend Sandstone Blend
Chesapeake Blend
Small Unit
3" x 6" x 10"
