KING CANOPY Universal C8GH1020 User manual

Universal™Greenhouse 10ft X 20ft
10ft8in Wide x 20ft Deep x 6ft8in Side Height /
9ft9in Center Height
King Canopy Item #: C8GH1020
With 8 Legs, Cover, Side Wall kit with Windows, Elastic Ball Straps &
Foot Pads
WARNING:
Keep all ame and heat sources
away from this tent fabric. Meets
the ammability requirements of
CPAI-84 Sec 6 and NFPA 701. It is not
re proof. The fabric will burn if left in
continuous contact with any ame source.
Distributed By:
PIC America, LTD.
8009 Purfoy Road • Fuquay-Varina, NC 27526
1-800-800-6296 • www.kingcanopy.com

6X6PC 17 pc 78” Pipe
5X8PC 8 pc 68” Pipe
3WPC 6 pc 3-way Connectors
4WPC 6 pc 4-way Connectors
BALLW 125 pc Elastic Ball Straps
PFOOT 8 pc Foot Pads
T81020SWW-BS-GH 2 pc Side Walls with Screen Windows
T81020EWZ-GH 1 pc Front Wall with Zippers
T81020EWW-BS-GH 1 pc Rear Wall with Screen Window
PTCL1020GH 1 pc Greenhouse Cover with Leg Skirts
PTCL1020VS 4 pc Valance Straps (4 pack)
PARTS LIST

FRAME ASSEMBLY
Step 1
Separate all pieces according to size and shape and arrange per the illustration shown below.
Please note:
•The 68in pipes are used to form the roof rafters
•The 78in pipes are used to form the roof perimeter and for the legs
Step 2
NOTE: Attach the cover before inserting the legs.
DO NOT CONNECT LEG POLES AT THIS POINT!
78’’ 78’’ 78’’
68’’68’’68’’ 68’’
78’’ 78’’ 78’’
68’’68’’68’’ 68’’
78’’ 78’’ 78’’
78’’ 68’’
Set aside eight 78”
pipes to use for legs.
78’’
Start Here

COVER ASSEMBLY
Step 1
should be located at each of the 4 corners of the frame.
Step 2
Begin attaching the cover with the elastic ball straps by inserting the elastic cord of the ball strap under-
neath the cover and through the grommet. Then pull cord taut until ball stops. Wrap the cord around the
•Start by attaching 2 elastic ball straps at each of the four corners
•Continue attaching straps from left to right in a zigzag pattern down both sides of the canopy
•Attach straps at the front and back of the unit, again using a zigzag pattern until all straps are secured
Note:
can be shortened by making an additional knot in the cord strap. Slide the ball upward to reveal the tied
knot. Tie a new knot above the old one. The size of the knot will determine how short the strap becomes.
Slip the ball down over the new knot and secure.
Inside View Outside View
Start at Corners Go Left to Right
Go Front to Back End Here

WALLS AND LEGS ASSEMBLY
Step 1
Unfold each of the walls.
• The front wall features 3 zippers, one on each side and one in the center.
• The rear wall is solid woth no zippers.
• The side walls of the unit feature 3 windows each
Step 2
Find the hook & loop fastening strips on one length of the rst sidewall to be assembled. These strips are to
be placed on the top pipe of your canopy structure by wrapping the fastening strips over the perimeter poles.
Repeat with second side wall, rear wall and front wall.
Note:
You may attach the side and rear walls with the window shades facing either the inside or outside of the unit.
They are designed to be assembled either way.
NOW, CONNECT THE LEG POLES TO THE ROOF ASSEMBLY WITH THE COVER ALREADY POSITIONED ON
TOP OF THE UNIT.
Step A: First insert the pipes for the middle poles into the 3- and 4-way
connectors, and then connect the end leg pipes in the same way.
(See illustration)
Step B: Push the eight foot pads onto the bottom of each leg.
NOTE: the foot pads are NOT for anchoring the canopy!
Step C: Connect the hook & loop fastening strips down
the length of each leg.
Step 3
After connecting the top of the side walls and installing the leg pipes into the connectors on the perimeter of
the unit, use elastic ball straps to connect the end of each sidewall to the 4 corners of the unit.
IMPORTANT! Once the legs and cover are assembled, your canopy will act like a kite in the wind. It is
imperative that the canopy anchors be installed NOW!

INSTALLING THE LEG SKIRTS
Step 1
After the legs have been connected to the roof using the 3- and 4-way connectors and your canopy has been
securely anchored, attach the leg skirts using elastic ball straps and the grommets at the top of the unit.
(Make sure that the end walls are underneath the ared leg covers to minimize rain and other elements from
entering inside the canopy unit.)
Step 2
Next secure the ared leg covers over the 4 corners (and outside the walls) by fastening the fabric loops
located at the bottom of each leg skirt over the anged clip on the foot pads.
To complete the assembly and securing of your unit, nish installing elastic ball straps completely around the
unit at the top and bottom wherever there is a grommet. Ball straps at the bottom of each side panel should
be attached to the anged clip on the foot pads.
Lastly, attach the 4 valance tie downs from the top grommet to the bottom grommets, securing to the foot
pads using the clips on end of the straps.
FINISH ASSEMBLY OF YOUR CANOPY

ANCHORING YOUR UNIT
This canopy is designed for use as a temporary structure. After assembly, the canopy MUST BE securely
anchored to the ground to prevent damage from winds. Your canopy will act like a kite in the wind if not
properly and securely anchored to the ground. Severe winds will cause the frame to twist and unanchored
legs will fall, thereby collapsing the canopy. If severe winds are expected, you must remove the cover from
the frame to prevent damage.
Step 1
Measure out at least 36in from each leg. Screw each anchor into the ground leaving 2in between the gr
ound
and the eye of each anchor. We strongly recommend that your unit be anchored 36in from each leg
although this may not be possible in all cases. DO install anchors as close to 36in away from legs as possibl
e.
Step 2
Tie anchor cable or rope around the connector at the top of each leg of the canopy.
Step 3
Securely tie the other end of the cable or rope through the eye of the anchor and pull tight.
Step 4
This will secure the anchor rope even tighter.
NOTE: You should check and tighten the rope frequently to ensure maximum stability of your canopy and
to protect against wind damage.
ANCHOR KIT NOT INCLUDED
WITH THIS CANOPY
INSTALLING THE LEG SKIRTS

IMPORTANT NOTICE: PLEASE READ CAREFULLY
We are condent that you will be completely satised with your King Canopy unit. Please take a
moment to read the very important information below, and call us with any questions you may have.
King Canopy/PIC America, LTD. has no control over wind, snow, ice, rain or any other weather condition and
we are in no way responsible for any damage caused by the canopy or to the canopy. We suggest you contact
your insurance carrier just as you would for any other outside structure.
OTHER PRECAUTIONS WHICH MUST BE FOLLOWED:
Keep all ame and heat sources away from this tent fabric. The tent fabric will burn if left in continuous
contact with any ame source.
DO NOT cook underneath or near canopy.
DO NOT store or use ammable liquids underneath or near canopy.
DO NOT ignite or store reworks underneath or near canopy.
DO NOT use bleach to clean cover.
DO NOT dry clean cover.
DO NOT wash cover in washing machine or dry in dryer. Hand wash with mild soap and water only.
DO NOT allow rain water, snow or ice to accumulate on top of cover.
DO NOT hang or suspend anything from the frame, grommets, truss system or ball straps of the unit.
REMOVE canopy cover before a storm, or disassemble entire canopy unit if possible.
REMOVE rain water, snow and ice from canopy cover.
This is a temporary structure and is not recommended for use as a permanent structure.

PRODUCT INFORMATION
Defective Parts
We try our best to eliminate any defective parts that are shipped with our products. If, however, you should nd
a defective part, we will replace – free of charge – any part which is defective. You will need to provide proof
of purchase showing date of purchase and provide us with detailed description of the defective component.
Your replacement will be shipped by ground shipping, freight prepaid. Next day or express shipping will
require freight collect and paid for by you, the consumer. Damages from improper anchoring, strong winds,
snow, ice or rain are not considered defects.
Improper Anchoring, Strong Winds, Rain Snow, or Ice
King Canopy/PIC America, LTD. does not guarantee these canopies under strong weather conditions. These
canopiesaredesignedto protect against damages caused by sun, rain,treesap, birds,etc. Theyarenotdesigned
to hold roof loads that accompany snow, ice or heavy rains. If your canopy is not anchored securely, it can be
lifted by the wind and will y away. If your canopy takes ight, we are not responsible for any replacement. If
you know strong weather is predicted, remove the cover or take down the canopy unit completely. The cover
is designed to be quickly and easily removed.
Warranty
All components of this canopy feature a 1-year limited warranty and are warranted to be free from defects in
material and workmanship for a period of 1-year. You must complete and return the enclosed warranty card
promptly after purchase. Please retain your proof of purchase receipt; you will be asked to provide this receipt
in order to obtain warranty service.
Non-Warranty Replacement Parts
If after expiration of the warranty period, you require replacement parts please contact us at 1-800-800-6296.
We stock replacement parts and make them available to you at discounted prices. Our customer service
department will be pleased to assist you in any way possible.
Certain regions of the country are extremely hard on covers of any kind. Normal wear and tear is not covered
under the warranty, and should be expected.
In order to receive a discounted or free replacement part, you may be asked to return the part, freight prepaid,
to our warehouse for inspection before we will send a replacement. You must, in all cases, provide a copy of
your receipt showing the date of purchase, model number and price.
For missing parts, replacement parts or any questions:
Please Call 8:00am – 5:00pm EST, Monday –Friday
1-800-800-6296 or 1-919-552-2977
Or you can fax us at: 1-919-552-5069
Replacement parts and customer service is also available through our website.
Please visit us at www.kingcanopy.com