KINGrinder K4 User manual

Receiver
Spring
White O-Ring
Black O-Ring
PC Lid Handle
Ball
Top Bearing
Top Bearing Cover
Adjustment Nut
Bearing Cover
Circlip
Burr Set

KINGrinder
The Exterior Adjustment of K4 and K6 manual coffee grinder
KINGrinder Manual - Exterior Adjustment
How to operate?
1. Rotate anti-clockwise to the desired grind setting from zero.
2. Take out the handle and the PC lid, load 30~35g of coffee
beans into it.
3. Put on the handle and the PC lid then spin the handle clockwise
till it has done.
The grinder can grind with a 6.35mm electric drill.
•Both O-ring(s) are an optional selection.
•The function of the white O-ring (14*10*2 mm) is to attach the
handle and the PC lid.
•And the black O-ring (31*27*2 mm) attaches the PC lid to avoid
abrasion.
How to adjust grind setting?
1. Rotate the adjustment nut clockwise till tightened. The
corresponding number is zero and the number on the
adjustment nut may not be the same as the number of clicks
from the grind setting.
2. Rotate the adjustment nut anti-clockwise from the zero to your
grind size.
3. Rotate the adjustment nut anti-clockwise for a coarser grind
and vice versa.

How to disassembling?
1. Rotate the adjustment nut anti-clockwise for a coarser grind
before dismantling the grinder.
2. Hold down the burr set with a hand and remove the circlip with
another hand.
3. Take out the components in order. The burr set (attached with
the central shaft), the spring and the bearing cover from the
bottom. Then the top bearing cover and the top bearing from
the above.
How to assembling?
1. Put on the components in order. The bearing cover, the spring
and the burr set from the bottom.
2. Then the top bearing and the top bearing cover. There are two
shapes of the top bearing cover: flat design and curve design.
The curve design shape of the top bearing cover facing upward.
3. Hold down the burr set with a hand and slide the circlip onto the
curve design shape of the top bearing cover with another hand.
What’s to do and not to do?
• Cleansing with a brush.
• Don’t wash the grinder with water.
• Don’t disassemble the burr ring unit and the adjustment nut.
Contact us via [e-mail] or visit www.kingrinder.com