FTD7000 CONTENTS
機型編號說明 MODEL NUMBERING -------------------------------------------------------------------
1 規格 SPECIFICATION ------------------------------------------------------------------------------------
2 半沉式車板安裝 SEMI SUBMERGED TYPE ----------------------------------------------------------
3 使用前說明 BEFORE OPERATION ---------------------------------------------------------------------
4 潤滑油及冷卻油 LUBRICATION OIL AND COOLING OIL -----------------------------------------
4-1. 選用潤滑油及冷卻油 LUBRICATION OIL AND COOLING OIL ------------------------------
4-2. 添加潤滑油 FEEDING OIL -------------------------------------------------------------------------
4-3. 換油 CHANGING OIL -------------------------------------------------------------------------------
4-4. 潤滑油過濾器 OIL FILTER -------------------------------------------------------------------------
4-5. 添加冷卻油 ADDING COOLING OIL -------------------------------------------------------------
5 針 NEEDLE -------------------------------------------------------------------------------------------------
5-1. 針號選擇 NEEDLE SELECTION -------------------------------------------------------------------
5-2. 正確的安裝針 HOW TO REPLACE THE NEEDLES ----------------------------------------------
5-3. 穿線 THREADING -----------------------------------------------------------------------------------
6 與縫製有關的各項調整 PROPER OPERATION ADJUSTMENT ------------------------------------
6-1. 壓腳壓力 PRESSURE OF PRESSER FOOT -------------------------------------------------------
6-2. 縫線張力 THREAD TENSION ----------------------------------------------------------------------
6-3. 進給率調整 ADJUSTING STITCH LENGTH -----------------------------------------------------
6-4. 差動比例調整 ADJUSTING DIFFERENTIAL FEED --------------------------------------------
6-5. 針線收放量調整 ADJUSTING THE NEEDLE THREAD TAKE-UP ---------------------------
6-6. 下結線鉤縫線收放量調整 ADJUSTING THE LOOPER THREAD TAKE-UP ----------------
6-7. 上裝飾線收放量調整 ADJUSTING SPREADER THREAD TAKE-UP ------------------------
7 與內部機構及時序有關的各項調整 ADJUSTMENT OF MACHINE -------------------------------
7-1. 更換壓腳及設定提昇高度
ADJUSTING PRESSER FOOT AND SETTING THE HEIGHT OF PRESSER FOOT -----------
7-2. 針棒高度及針落點
ADJUSTING THE HEIGHT OF NEEDLE BAR AND NEEDLE DROP POINT ------------------
7-3. 安裝下結線鉤 INSTALL LOOPER ----------------------------------------------------------------
7-4. 下結線鉤定位 SETTING LOOPER ----------------------------------------------------------------
7-5. 下結線鉤與針的間隙 THE CLEARANCE BETWEEN LOOPER AND NEEDLE -------------
7-6. 針與後導針器 THE RELATION BETWEEN NEEDLE AND REAR NEEDLE GUARD -----
7-7. 針與前導針器 THE RELATION BETWEEN NEEDLE AND REONT NEEDLE GUARD ----
7-8. 設定送布齒高度 SETTING THE HEIGHT OF FEED DOGS ------------------------------------
8 裝飾縫 TOP COVERSTITCH ----------------------------------------------------------------------------
8-1. 上裝飾縫結線鉤安裝及定位 INSTALLING AND SETTING THE SPREADER--------------
8-2. 安裝裝飾線導線板 SETTING THE TOP CIVER THREAD GUIDE ----------------------------
9 FTD車板圖 TABLE CUT-OUT FOR FTD TYPE -------------------------------------------------------
9-1. 半沉式 SEMI SUBMERGED TYPE ----------------------------------------------------------------
9-2. 全沉式 FULLY SUBMERGED TYPE --------------------------------------------------------------
1
2
3
3
3
3
4
4
4
5
5
5
5
6
7
7
7
7
8
9
10
11
11
11
12
12
13
13
14
14
15
15
15
16
16
17
17
