Kingwo MT02S User manual
Shenzhen Kingwo IoT Co., Ltd.
PRODUCT MANUAL
User Manual
MT02S
GPS Tracking sulutions
Declaration
new version of this manual. KINGWO will improve or update
the products or procedures described in the manual at any
does not match the actual product, the actual product shall
manual.
03
02
01
03
04
05
CONTENTS
04
09
10
17
；
01 Production
Intruduction
Product Feature
Product appearance
02 Function
When the vehicles enters the GPRS blind area, the device will store the GPS
LBS
AGPS
The device supports AGPS, once the device is connected to GPRS, the AGPS
Power Save
GPS error alarm
remotely.
switches to the standby server. The primary server and the standby server
can be set in either IP or domain name.
03 Parameters
Characteristics
Main Unit
Frequency
GNSS Parameters
，applicable to12V/24V vehicles
（），
（）
1，
82mm*23mm*13mm（）
℃～℃
℃～85℃
5%～
Quad band：
Description
04 Installation
guide
【】
Switch
on.
Open the top cover
of the device
【】
白色
2A fuse
Battery
black
gules
orange
yellow
Fuel
Fuel
Ignition Switch
【】
Under rear
windshied
Around dashboard
Under front
windshield
Near the
Under the
【】
T3：
，
，
，，：
，
：，
：
Set APN, User name and password
：
，，
，，
Reboot device
16
，
，，
FCC WARNING STATEMENT
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment. This equipment has been tested and found
to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures: -- Reorient or relocate the
receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
CONTACT US
17
Other manuals for MT02S
1
Table of contents
Other Kingwo GPS manuals
