Kiwi Camping Rifleman 2 Configuration guide

1. Select a dry, level site
and clear the ground
of any sharp objects.
Remove the tent from
it’s carry bag, untie
fabric ties and unroll the
tent. Save the fabric ties
to make packing away
the tent easier.
2. Spread out the floor
of the inner tent and
peg out the eight main
pegging points first,
ensuring that the tent is
pulled taut and secure.
3. Assemble both aluminium poles by interlocking all
sections. Insert the GOLD pole through the black
sleeve on the inner at the narrowest end and place
the pole ends onto the pins (on the ring) at the base
of the inner. Repeat with the BLACK pole through
the larger sleeve. Attach the speed hooks to the
corresponding poles. The inner tent is now pitched.
To make sure the tent
stays in place, insert the
pegs into the ground at a
45° angle.
Pitch the tent so it is in
line with the wind, never
side on.
4. Carefully pull the fly over the inner tent. On the
underside of the fly attach the Velcro ties to the
corresponding poles. This will align the fly and
helps in windy conditions. Once aligned, use the
black side release clips to secure and adjust the fly.
5. Finally, peg out all guy ropes and fine tune the fly so it
remains taut and positioned correctly over the tent for
ultimate stability.
Rifleman 2 Hiker Tent
Model No. KC072-440
Your tent includes:
16 x pegs
4 x ropes
1 x GOLD aluminium pole (1570mm x 9.5mm)
1 x BLACK aluminium pole (3020mm x 9.5mm)
PITCHING INSTRUCTIONS
PACKING INSTRUCTIONS
Pack the poles and pegs into their bags. Evenly lay out the
outer fly inside the tent inner leaving all doors and windows
open. Fold the inner tent floor from each side to the centre
and in half again. Adjust to the length of the poles. Place the
poles onto the floor and roll them inside so that the floor is
on the outside. Store and pack the tent in it’s bag.
REVERSE THE PROCEDURE TO LOWER THE TENT
Filename: 5041_KC072-440_Rifleman-2_Instr.pdf
Dimensions: 280mm W x 150mm H
Colour: Black
Use caution when inserting poles so not to damage sleeves.
The black fly window should be at the narrow end of the tent.

The original purchaser of this product is offered a warranty if
during this time period the product fails due to a fault in either
materials or workmanship. Service under this warranty is available
by returning the product, with your proof of purchase, to where it
was purchased. If after inspection it is determined that the product
is defective, we will repair or replace it (at our discretion) free of
charge. This warranty does not cover misuse, damage caused by
accident, storm or wind damage, mildew, neglect, UV degradation
and fair wear and tear. Please note, the warranty on this tent will
be deemed void if the product is used for any purpose other than a
temporary shelter. If the claim is not deemed a warranty or is outside
it’s warranty period, we can repair the product at a nominal cost.
TENT CARE INSTRUCTIONS
PLEASE READ ALL OF THE TENT CARE INFORMATION
AND INSTRUCTIONS INCLUDED WITH THIS TENT
BEFORE USING YOUR TENT FOR THE FIRST TIME.
1. Before you use your new tent, fully unpack and pitch it at home.
It is important to familiarise yourself with the set up procedure
and the various features.
2. Select a site that is level, clear of any sharp objects, is dry,
will drain well if it rains and is protected from wind and other
elements.
3. Keep clear of overhead power lines and trees when setting up
your tent.
4. For best and easiest results, enlist the help of at least one other
person to assist in pitching the tent.
5. Keep all flame and heat sources away from this tent fabric. Do
not use open flame or gas appliances in or near your tent.
6. Do not use aerosol sprays or any solvent based products
in or around your tent as these could damage the fabric or
special coatings. These products include but are not limited
to: repellent spray, hair sprays, alcohol, detergents, fly spray,
petrol, kerosene etc.
7. Please note, the warranty on this tent will be deemed void if
the product is used for any purpose other than a temporary,
recreational use shelter.
8. Handle the tent poles carefully. When unfolding and folding
the tent poles, do not allow the shock cord to pull and snap the
ends together. This can damage the poles ends and result in
breakage when the pole is tensioned.
9. Especially in windy conditions, it is essential that you attach guy
ropes and fasten them to the ground. We suggest you insert the
pegs into the ground at a 45° angle towards the tent, not
straight down. Please note, your tent will nor be covered
under warranty if wind damage occurs.
10. Use all of the guy ropes and pegs included to ensure
your tent is secure and to prevent damage to both
yourself and the tent. Check guy ropes/pegs daily.
11. Ensure there is an adequate gap between the fly
and inner tent to enable ventilation and to prevent
condensation build up.
12. Hold the flaps up, when closing the doors, to take
pressure off the zips. Ensure that the tent fabric is never
over stretched, especially as this may cause problems
with the internal doors.
13. To clean your tent, only ever use a soft sponge and warm
water. DO NOT use excess force or other harsh cleaners
to remove marks from tent.
14. Ensure the tent is completely dry and clean before
storing away and ensure to store it in a dry environment.
IMPORTANT:
1. Under certain conditions (cold weather, high humidity
etc.) condensation may form on the inside of your tent
fly. Condensation can occur for many reasons including
vapour from your breath, perspiration, cooking nearby
or wet clothing inside your tent. This does NOT mean
your tent is leaking through the fabric. You can minimise
condensation by opening windows and airing out your
tent during the day and by removing any wet clothing/
towels etc.
2. Try to avoid pitching your tent under trees as tree limbs,
falling leaves, sap, bird droppings or excess water
dripping from the trees can cause damage to the tent
fabric and its special coatings resulting in leakage or
discolouration.
WARRANTY INFORMATION
The warranty period for this tent is found on the packaging
and full details are on the Kiwi Camping website
- www.kiwicamping.co.nz.
3. Only remove the tent pegs by pulling on the peg itself.
NEVER pull on the tent or the webbing loops to remove
pegs as it could result in damage to the tent or personal
injury.
4. DO NOT leave tent pitched for weeks at a time as extended
exposure to the sun’s ultraviolet rays can damage and/or
cause it to discolour. Your tent will not be covered under
warranty if you leave it up for many weeks at a time.
5. STORAGE:
NEVER store your tent wet or dirty (even for short periods
of time).
NEVER store your pegs or poles inside your tent. Always
use the separate bags they are supplied in.
6. You may want to insure your tent against loss or damage.
Distributed by: Aber Living, Hamilton, NZ
www.kiwicamping.co.nz
5041-09/18
Key points:
Filename: 5041_KC072-440_Rifleman-2_Instr.pdf
Dimensions: 280mm W x 150mm H
Colour: Black