Kiwi Camping KC077-056 User manual

Filename: 5523_KC077-056 Tuatara Plateau Rooftop Tent Instructions
Dimensions: A5 Booklet
Colour: Black
SAFETY INSTRUCTIONS
• Regularly check nuts and bolts attaching the Rooftop Tent to your vehicle to make sure
fastenings are tight and in good condition.
• Remove the Rooftop Tent before using a commercial car wash.
• Do not use Rooftop Tent or storage bag to hoist, lift or support yourself.
• It is important when mounting to a vehicle, that all the mounting brackets supplied are
adequately spaced to support the weight of the Rooftop Tent.
• Products applied to a vehicle roof will alter vehicle handling. The manufacturer disclaims
all responsibility in relation to accidents due to improper use, incorrect maintenance, or
negligence in maintaining fastening hardware. It is recommended to not exceed 100km/h.
• This Rooftop Tent will increase the height of your vehicle. Measure the overall height and be
aware of height restrictions in car park buildings etc.
• If pitching in windy conditions it is advised to find a less exposed location. Park with the back
of the tent facing into the wind. Be aware of dropping branches and other potential hazards.
Collapse the tent in strong winds.
• Never drive with roof tent erected.
• Do not put anything on the top of the tent when it is installed.
• The load-bearing of the frame is no more than 300kg.
TUATARA PLATEAU
ROOFTOP TENT
Model No. KC077-056

2
Filename: 5523_KC077-056 Tuatara Plateau Rooftop Tent Instructions
Dimensions: A5 Booklet
Colour: Black
PARTS INCLUDED
YOUR TUATARA PLATEAU ROOFTOP TENT INCLUDES:
1 x pre-assembled Rooftop Tent with ladder attached
4 x spacers
2 x storage bags
8 x M8 x 60 bolt sets (hexagon head bolt, nut and washer)
8 x M8 x 40 bolt sets (hexagon head bolt, nut and washer)
4 x mounting brackets
8 x slide plates
8 x M8 self-locking nuts
8 x M8 washers
4 x plastic end caps
2 x spring poles
2 x fibreglass window poles
2 x fibreglass window tensioners
1 x 13mm ratchet spanner
2 x 10mm spanners
You will also need:
1 x person to help attach the Rooftop Tent to the vehicle

3
ROOFTOP TENT INSTALLATION
The Tuatara Plateau can be fitted to smaller vehicles as long as the
fitted roof rack or crossbars support a dynamic weight load of 75kg
or higher. We recommend using only permanent roof racks and
crossbars. The distance between the car roof and the bottom of the
roof rack should be no less than 3cm. The roof rack or crossbars
must be between 80-100cm distance apart.
1. Decide on the orientation of your Rooftop Tent. Ensure the two
mounting rails attached to the Rooftop Tent are fixed to the
correct position and allow for even weight distribution.
2. Carefully lift the Rooftop Tent on to the roof rack. This will
require two people. Position the tent in the centre of your
vehicle. Ensure the roof racks are evenly spread under the
Rooftop Tent. The three latches indicate the opening side of
the Rooftop Tent. We recommend keeping the hardshell facing
front to rear of the vehicle for maximum frame strength.
3. To help fit the mounting brackets onto thinner roof racks, we
supply roof rack mounting spacers. Use these to make your
Rooftop Tent more secure.
4. Insert the supplied M8 x 60 bolts through the holes on the
grooved side of the eight slide plates.
5. Attach the Rooftop Tent at the four points where the roof rack
and the frame meet. Slide two slide plates and M8 x 60 bolts
into both ends of each mounting rail. Position so one bolt is on
either side of each roof rack. Loosely hand tighten.
Use the shorter M8 x 40 bolts if the distance between the car roof and
the roof rack is under 4cm.
6. Check the alignment and balance of the Rooftop Tent before
fully tightening all bolts. Ensure all eight points are tightened
evenly using the M8 nut and washers using the 13mm spanner.
7. Place the plastic end caps over each end of the mounting rails
to prevent wind noise.
8. Attach the storage bags by sliding into the track on each side of
the ladder.
Remember to remove the scratch-resistant film from the shell and
base before taking the tent out for its first use.
4
5
7
2
8

4
Filename: 5523_KC077-056 Tuatara Plateau Rooftop Tent Instructions
Dimensions: A5 Booklet
Colour: Black
7
PITCHING INSTRUCTIONS
1. Before opening your Tuatara Plateau Rooftop Tent, ensure that
all eight bolts are fastened tight so that the tent does not move
when opening.
2. Unlock the three latches on the side of the hardshell. Holding
down the button on the side of the latch, pull the latch forward
and unhook the strap from under the body of the tent.
3. Press down on the top of the hardshell, above the compression
straps to make it easier to open the Rooftop Tent. Undo all
three compression straps by pressing the button under the
strap.
4. Push up the hardshell, the automatic gas struts will open it
fully.
5. Unclip the ladder’s travel strap and fully extend the ladder
until you hear all the telescopic rungs click into place.
6. Once the ladder is fully extended, use the ladder as leverage to
fold out the extension section on the Rooftop Tent.
7. Once unfolded, adjust the height of your ladder starting at the
top by pushing both black buttons at the same time. Shorten
the ladder rungs to the desired length so that it is at a 75°
angle and the extension is sitting level with your vehicle.
Excess ladder rungs should be stored at the top. Adjust the
ladder to ensure it is firm and that it does not bounce or move.
Undo the internal bungee that pulls the body in when packing
down.
3
4
5
6

5
Filename: 5523_KC077-056 Tuatara Plateau Rooftop Tent Instructions
Dimensions: A5 Booklet
Colour: Black
8
9
10
8. Locate the two pole mounts on the front side of the frame.
Insert the two spring poles through the canvas slits and into
the holes. Angle the poles toward the inside edge of the pole
mounts. Insert the top of the poles into the eyelets at the top
corners of the porch. Ensure the hook ends face outward. Fold
the fly back over the ends of the spring poles.
9. To pitch the side windows, assemble the fibreglass poles. Feed
the longer poles through the window power mesh sleeves and
secure each end by placing the pole into the pole connector.
10. Tension out the side windows by inserting each end of the
shorter fibreglass poles into the corresponding pockets on the
middle of the fly and window extension.
11. Once inside the Rooftop Tent, partly open the windows to
allow for airflow, this will help to reduce condensation
build-up. The side windows can be rolled up for faster pitching.
12. Attach the awning or annex if required (sold separately).

6
Filename: 5523_KC077-056 Tuatara Plateau Rooftop Tent Instructions
Dimensions: A5 Booklet
Colour: Black
8
6
7
5
PACKING INSTRUCTIONS
1. Ensure the Rooftop Tent is dry and clean inside and out before
packing down so that mildew or mould does not build up.
2. Make sure nothing heavy or bulky is left inside the Rooftop
Tent before folding. If leaving a small amount of bedding in
the Rooftop Tent, store it at the top.
3. Zip up the window mesh but only zip half of the window so
that the air can escape from the tent when folded.
4. Remove the side window fibreglass poles and the two front
spring poles and place them back into the bag. Place the
poles under the mattress of the tent. Reattach the bungee
that will compress the body when packing down.
5. Use the extended ladder as leverage to fold the Rooftop Tent
in half.
6. To compress the ladder, press and hold both buttons on the
bottom rung to collapse it up. Secure with the strap.
7. Pull the hardshell down using the attached strap. When
pulling the cover down ensure all the fabric is tucked inside
the hard shell.
8. Insert the compression straps starting in the middle and
working towards the outside. Push down on the top of the
Rooftop tent to ensure that the tent is fully compressed.

7
1. Never store your Rooftop Tent away damp. Should mildew spots appear, brush them o before
they become attached. Mildew damage of any kind is not covered by our warranty. DO NOT use
excessive force or other harsh tools to remove soilage from your Rooftop Tent.
2. Like all assets, polyester fabric requires regular care and attention to give the life and service
expected. Regular cleaning with an abundance of clean water and a soft brush, especially after
exposure to saltwater will preserve your Rooftop Tents life. Do not allow bird droppings, earth or
vegetable matter to remain in contact with the fabric. NEVER USE SOAPS OR DETERGENTS.
3. Polyester fabric is not fireproof, if exposed to flame or high heat sources it can ignite and burn.
Always take care when using spirit or gas appliances such as stoves and lanterns near your
Rooftop Tent.
4. Some products contain chemicals, which can destroy your Rooftop Tent proofing and cause it to
leak. Avoid using aerosol sprays and keep petrol, oil, solvents and other similar fluids away from
the fabric. Do not use these inside or around your Rooftop Tent as any damage caused by these is
not covered by our warranty.
5. Always remember that your Rooftop Tent is made from cloth, and should not be compared with
a house. It is waterproof under normal conditions but in severe weather conditions, some water
may penetrate. If you apply waterproofing to your Rooftop Tent, check that you are applying the
right one for the polyester fabric type.
6. Polyester fabric is not 100% colourfast and some fading will occur naturally, however; this does
not aect the performance of the fabric. Do not leave your Rooftop Tent up and unattended for
extended periods of time. Rooftop Tents are not designed as permanent dwellings. Rooftop Tents
are guaranteed for normal camping use only.
7. Check all fixtures regularly and tighten them when necessary.
8. Always wash tent and frame if the Rooftop Tent is exposed to coastal or salty conditions.
9. Remove the mattress before storing for long periods. Air the tent and mattress regularly to
prevent dampness in bedding.
CARE INSTRUCTIONS
PLEASE READ ALL OF THE CARE INFORMATION AND INSTRUCTIONS INCLUDED WITH THIS ROOFTOP
TENT BEFORE USING IT FOR THE FIRST TIME. THE BODY OF THE TUATARA PLATEAU IS RIPSTOP
POLYESTER CANVAS AND THE FLY IS RIPSTOP POLYESTER.
Filename: 5523_KC077-056 Tuatara Plateau Rooftop Tent Instructions
Dimensions: A5 Booklet
Colour: Black

8
The original purchaser of this product is oered a warranty if during this time period the product fails due to a fault in either materials or workmanship.Service
under this warranty is available by returning the product, with your proof of purchase, to where it was purchased. If after inspection it is determined that the
product is defective, we will repair or replace it (at our discretion) free of charge.This warranty does not cover misuse, damage caused by accident, storm or
wind damage, mildew, neglect, UV degradation and fair wear and tear.Please note, the warranty on this Rooftop Tent will be deemed void if the product is used for
any purpose other than a temporary shelter. If the claim is not deemed a warranty or is outside its warranty period, we can repair the product at a nominal cost.
Filename: 5523_KC077-056 Tuatara Plateau Rooftop Tent Instructions
Dimensions: A5 Booklet
Colour: Black
Distributed by: Aber Living, Hamilton, NZ
www.kiwicamping.co.nz
5523-08/23
WARRANTY INFORMATION
The warranty period for this awning is found on the packaging and full details are on the Kiwi Camping
website - www.kiwicamping.co.nz.
IMPORTANT INFORMATION
1. Ensure the Rooftop Tent is clean and dry before it is packed away.
2. Store in a clean, dry space when the Rooftop tent is not attached to your vehicle.
3. Do not clean with harsh chemicals, only use water and a soft cloth.
4. Before using the ladder, ensure that all parts are locked. Check regularly to ensure all parts are in
good condition and in working order.
5. Do not use the ladder if only supported by one leg. If on ice or unstable ground, use an anti-skid
device under the ladder.
6. When climbing the ladder, face the ladder while climbing and hold firmly. Step in the centre of the
rungs. Do not jump o the ladder.
7. Do not adjust the ladder while on the ladder.
8. Before contracting the ladder, ensure it is clean from dirt, dust and grease.
9. The frame and ladder are metal and will conduct electricity, keep away from live electrical
currents.
10. The ladder should be at an angle of 75° to the ground when in use.
11. When extending the ladder. Start at the top, extend slowly in sequence, locking each rung
carefully before moving to the next. Grip from the bottom.
12. When contracting the ladder. Start at the bottom, click the buttons on the underside of the rungs
and collapse slowly in sequence, working to the top of the ladder. Fasten the travel strap.
13. If the extended ladder isn’t sitting flat, reduce the entire ladder first, then extend again to the
correct height, starting from the top.
14. Do not use the tent and ladder in extremely high winds.
15. The ladder is designed for one person only, maximum load 150kg.
16. Do not jump inside Rooftop Tent.
17. Do not leave children unattended in or around this Rooftop Tent.