Button "OFF 2"
Pushing that button controller "TEMP2" will be
switched to "OFF". Again pushing it, will switch
the controller "TEMP2" to "ON" again.
Button "TEMP1"
Keep button pushed to adjust the set heating
temperature of TEMP1 with the "UP" or "DOWN"
buttons. For fixing your adjustment release
the "TEMP1" button at last.
Button "OFF 1"
Pushing that button, controller "TEMP1" will be
switched to "OFF". Another push will switch
the controller "TEMP1" to "ON" again.
Button "UP":
By pushing that button the value of the
selected parameter "P" will be increased
Button "DOWN"
By pushing that button the value of the
selected parameter "P" will be decreased
Button "TEMP2"
By pushing that button the display shows the
set heating temperature "TEMP2", Keep
button pushed to adjust the set heating
temperature of TEMP2 with the "UP" or "
DOWN" buttons. For fixing your adjustment
release the "TEMP2" button at last.
Fully electronic, programmable, mikroprozessor controlled
temperature controller and display for two KLS tyrewarmers.
E. Adjustments (1x for "High" temp, 1x for "
Low" temp)
When no button is pushed, the common display shows
the actual temperatures of the tyre surfaces of the the
front and rear tyre alternatively for 3 seconds each
The LED's "TEMP1" and „TEMP2" indicate, which temp is
actually shown on the display.
The lighting LED's „1“ und „2“ show, which tyrewarmer is
actually heated.
The buttons:
The TCU Duo controller is pre adjusted like follows:
Switchposition “LO”:
Temp1 and Temp2 = 55°C Switchposition “HI”:
Temp1 and Temp2 = 85°C
Temperature Control Unit TCU-2Duo
MOTO | TYRE WARMERS
OPERATION MANUAL
2 / 2
