KMART 42909200 User manual

Assembly Instructions
1
1PC 22PCS 34PCS
Hardware list
8PCSA
8PCSB
8PCSC
1PC
6PCS
D
E
42909200 DROP LEAF TABLE
24PCSF 3X12mm
G
M8X45mm
Flat Washer
Spring Washer
Allen Key
(M5)
Hinge
4PCS
Glide
CARE INSTRUCTIONS:
WARNING:
FAILURE TO FOLLOW THESE WARNING COULD RESULT IN SERIOUS INJURY. MAXIMUM SAFE LOAD: 30KGS FOR TOP PANEL.
WIPE CLEAN WITH SOFT DAMP CLOTH. DO NOT USE SCOURERS, ABRASIVES OR CHEMICAL SOLVENTS. STORE IN A DRY PLACE AND KEEP AWAY FROM DIRECT WATER
AND SUNLIGHT. FOR INDOOR AND DOMESTIC USE.
DO NOT STAND OR SIT ON THE PRODUCT. DO NOT USE THE PRODUCT AS A STEP LADDER. DO NOT USE THE PRODUCT UNLESS ALL BOLTS AND SCREWS ARE FIRMLY
SECURED.

STEP 1
STEP 2
STEP 3
STEP 4
AC
B
D
Fx24
Ex6
G
Attach board 2 onto board 1 with part E & F into the
corresponding position as per diagram.
Fixed leg3 onto board 1 with part B,C & A by hand, then tighten them using Part D. If you want to extend table top, push block of board 1 onto board 2 into the corresponding
position as per diagram.
Peel off self-adhesive tape of Glide G, stick them on the bottom of each leg .

STEP 5
If you want to fold the table top, push block of board 2 onto board 1 into the corresponding position as per diagram.
Finish the assembly.
ATTENTION:
DO NOT TIGHTEN THE SCREWS FULLY DURING ASSEMBLY.
FULLY TIGHTEN SCREWS AFTER THE FINAL ASSEMBLY STEPS.