KMART 43229154 User manual

43229154 RATTAN WARDROBE 2 DOOR HANGING RAIL WITH STORAGE SHELF
WARNING: DO NOT STAND, SIT OR LEAN ON THIS UNIT. DO NOT USE THIS UNIT AS A STEP LADDER OR AS A CHOPPING SURFACE.
KEEP AWAY FROM CHILDREN AND BABIES. ADULT ASSEMBLY REQUIRED. USE ONLY ON A FLAT SURFACE. ADULT ASSEMBLY
REQUIRED. DO NOT USE THIS UNIT UNLESS ALL BOLTS AND SCREWS ARE FIRMLY SECURED.
CARE INSTRUCTIONS: TO BE ASSEMBLED ON A CLEAN, DRY AND SMOOTH SURFACE. WIPE CLEAN WITH A SOFT DAMP CLOTH.
NEVER USE SCOURERS, ABRASIVES OR CHEMICAL SOLVENTS. CHECK AND TIGHTEN ALL PARTS REGULARLY. KEEP AWAY FROM
MOISTURE AND DIRECT SUNLIGHT. STORE IN A DRY PLACE. FOR INDOOR AND DOMESTIC USE ONLY.
MAXIMUM SAFE LOAD:15KGS FOR CLOTH RAIL,7.5KGS FOR BIG SHELF,5KGS FOR SMALL SHELF.

9
10
6
7
7
2
9
9

12
12
10
10
1
10

x 3 10
11
9
User instructions should include the wording:
It is strongly recommended that this
product is permanently fixed to the wall.
Please seek professional advice if you
are in doubt of what fixing device to use.
Regularly check that anchors are securely
maintained.
Stability of tall items may be affected by
thick pile carpet or uneven floors .
Do not place unanchored televisions on
furniture .
CAUTION: for your safety when attaching the anchor fixings,
please note the following:
Check any electrical wires or plumbing
inside the wall before drilling any holes
(if you are unsure please seek professional
advice from a qualified tradesperson).

K
KK
K
K
K
If the adjustable layer board is
installed, there is no need to install
the plastic doorstop; If you do not
want to install adjustable layer
board, please install this plastic
doorstop to keep the door from
buckling.

Hinger Adjustment Tips
Noted: The door might be scraping, bumping, misaligned when first assembly.
Please follow the below tips:
Adjust the door up and down 1. Loosen the two mounting screws on both hinges, but only slightly. ...
2. Gently close the cabinet door.
3. With the door still closed, adjust the cabinet door to the desired height.
4. Open the cabinet door again, being careful not to jostle the door out of position.
5. Retighten the screws by hand.
Move the door in and out If the door doesn't meet the box at the top, adjust the top hinge toward the cabinet and/or
adjust the bottom hinge away from the cabinet. If the door is gapped at the bottom, do the
reverse.
Move the door right or left You can adjust one or both hinges on each door, depending on how much correction it
needs. If the door seems to be tilting down to the right, turn the side-to-side screw on the top
hinge so the hinge pulls closer to the side of the cabinet box, moving the top of the door to
the left.