KMART 42909279 User manual

1
2
5
4
3
7
8
9
10
11
6
6
6
6
Assembly Instructions
1
1PC 21PC 31PC
4
1PC 51PC 64PCS
7
1PC 8
1PC 9 1PC
10
1PC 11 1PC
Hardware list
8PCSA
8PCSB
8PCSC
8PCSD
4PCSE
8PCSF
8PCSG
8PCSH
1PCI
42909279 BEDSIDE DRAWER WHITE
6X35mm
15x9mm
6x30mm
4X35mm
Glide
M6X45mm
Flat Washer
Spring Washer
Allen Key
CARE INSTRUCTIONS:
WARNING:
WIPE CLEAN WITH SOFT DAMP CLOTH. DO NOT USE SCOURERS, ABRASIVES OR CHEMICAL SOLVENTS. STORE IN A DRY PLACE AND KEEP AWAY FROM DIRECT WATER
AND SUNLIGHT. FOR INDOOR AND DOMESTIC USE.
DO NOT STAND OR SIT ON THE PRODUCT. DO NOT USE THE PRODUCT AS A STEP LADDER. DO NOT USE THE PRODUCT UNLESS ALL BOLTS AND SCREWS ARE FIRMLY
SECURED.LOAD DRAWER EVENLY TO PREVENT FROM TIPPING OVER. FAILURE TO FOLLOW THESE WARNING COULD RESULT IN SERIOUS INJURY. MAXIMUM SAFE
LOAD:10KGS FOR TOP PANEL,3KGS FOR DRAWER.

STEP 1
STEP 2
STEP 3
STEP 4
1
A
A
A
A
1
C
2
3
2
3
C
C
C
B
1
5
4
C
C
C
C
D
D
D
D
Fix part A onto board 1 into the corresponding position
as per diagram.
Attach board 2 & 3 onto board 1 with part B & C.
Put board 5 onto board 2 & 3 into the corresponding position as per diagram.
Attach board 4 onto board 2 & 3 with part C & D.

STEP 5
STEP 6
STEP 7
STEP 8
F
6
6
6
6
H
G
I
E
11
A
A
A
A
11
B
7
9
B
B
Attach leg 6 onto board 4 with part G,H,F & I.
Peel off self-adhesive tape of Glide E, stick them on the bottom of each leg .
Fix part A onto board 11 into the corresponding position as per diagram.
Attach board 7 & 9 onto board 11 with part B.

STEP 9
STEP 10
STEP 11
STEP 12
10
8
D
D
D
D
Put board 10 onto board 7 & 9 into the corresponding position as per diagram.
Attach board 8 onto board 7 & 9 with part D.
Attach the drawer onto Step 6 and then adjust drawer runner into corresponding position as
per diagram.
Finish the assembly.
7
9
7
9
OK
ATTENTION:
DO NOT TIGHTEN THE SCREWS FULLY DURING ASSEMBLY.
FULLY TIGHTEN SCREWS AFTER THE FINAL ASSEMBLY STEPS.
DO NOT PUT HOT ITEMS SUCH AS COFFEE CUPS DIRECTLY ON THE SURFACE OF PRODUCT!