KMART 42823407 User manual

Hardw
are list
42823407 KITCHEN BENCH PREP TROLLEY
CARE INSTRUCTIONS:
WIPE CLEAN WITH A SOFT DAMP CLOTH. DO NOT USE SCOURERS, ABRASIVES OR CHEMICAL SOLVENTS. CHECK AND TIGHTEN ALL PARTS REGULARLY. STORE IN A DRY PLACE AND
KEEP AWAY FROM DIRECT WATER AND SUNLIGHT. FOR INDOOR AND DOMESTIC USE ONLY.
WARNING:
DO NOT STAND ON THE TROLLEY. DO NOT USE THE TROLLEY AS A STEP LADDER. DO NOT USE THE TROLLEY UNLESS ALL BOLTS AND SCREWS ARE FIRMLY SECURED. ALWAYS SET
UP THIS ITEM ON A FLAT EVEN SURFACE. ENSURE PRODUCT IS STABLE AND LOAD EVENLY.KEEP AWAY FROM CHILDREN AND BABIES UNTIL ASSEMBLY IS COMPLETE. ADULT
ASSEMBLY REQUIRED. FAILURE TO FOLLOW THESE WARNINGS COULD RESULT IN SERIOUS INJURY. MAXIMUM SAFE LOAD: 15KG FOR TOP PANEL,3KG FOR DRAWER,5KG FOR WINE
SHELF,5KG FOR WINE BASKET,5KG FOR BOTTOM SHELF.
plastic drawer
stopper
wheel with
stopper
wheel w/o
stopper
plastic
handle&
screws
Osticker 8pcs

G
G
G
G
H
H
H
H
II
45
66
Attach board 9&10 onto board 11 with part C
Put board 12 onto board 9&10
Fix the part A onto board 13 and fix part B onto board 9&10
Attach board 13 to board 9&10 and then fix the round screws part B
with a screwdriver.
Attach part N with the matched screws.
Ensure all parts align.
Attach part I onto frame 4&5 with screw H and attach board 6 onto frame 4&5
with screw G (as per below diagram).
Put part F onto board 3&7 into the
corresponding position
(as per below diagram).
Put part D onto frame 4 into the
corresponding position
(as per below diagram).
Attach board 3&7 onto
frame 4 with screw E.

frame
frame
frame

Step 8 Step9
、
、
4 k
�
Tool requi『ed
Philips Head Screw Driver
(Not provided)
、
o
stickers here to cover the screw
holes,same as the other side.
Step10
Attach part L onto the legs on the short side with part K.
Attach part M onto the legs on the long side with part K.
Kindly reminder: part L is the wheel with stopper.
part M is the wheel without stopper.
Attach the drawer from step
1 and part 14 onto the trolley
from step 8. Put part O onto
the screw holes (as per
below diagram).
Finish the assembly.