Jeep®Wrangler
Keep this important
information for future
reference
WARNING: CHOKING HAZARD – Small parts.
Not for children under 3 years.
CAUTION: Keep hands, face, hair and
clothing away from all moving parts.
Battery Information
How to Insert and Remove Batteries
Insert 2 fresh AA batteries* (LR6) into the
compartment with the correct polarity (+/-)
as shown here.
* Not included
CAUTION: To Avoid Battery Leakage
•Do not mix dierent types of batteries.
•Do not mix alkaline, standard (carbon-zinc) or
rechargeable batteries.
•Do not mix new and used batteries. Only batteries
of the same or equivalent type recommended should be used.
•Remove exhausted batteries from the toy; do not short-circuit supply
terminals.
•Remove all batteries if the toy will not be used for a long period of time.
Important Tips
•Alkaline batteries are recommended.
•Rechargeable batteries are not recommended.
•Remove rechargeable batteries before recharging; they must be
charged only under adult supervision.
•Non-rechargeable batteries must not be recharged.
•Keep components free of dust; do not immerse or use in water.
•Do not dispose of batteries in a re; they could leak or explode and
cause injury.
Start Building
Each piece has its own shape and
color. Just look at the pictures, nd the
pieces in your set that match and then
connect them together.
Try to face your model in the
same direction as the instructions
while you build. The arrows show
you where the parts connect, but
not all connections points have
arrows. Faded colors show you this
section is already built.
Connectors
You can slide these special connectors
together. Push tightly until you
hear a “click”. Pay close attention to
the instructions and position them
horizontally or vertically
exactly as they are shown.
Spacers
There are places in your model where you need to
add spacers. Be sure to use the correct number of
spacers shown in the instructions.
1
2
1
Building
Basics
2
