KNEX COLLECT & BUILD FERRIS WHEEL User manual

IMPORTANT STUFF
FOR PARENTS & KIDS
Keep these i structio s i a ha dy
locatio . They co tai importa t
safety i formatio .
Read all war i gs a d i structio s
before you start to build a d
operate the model.
WARNING: CHOKING HAZARD -
Small parts. Not for C ildren under 3 years.
CAUTION: Keep ands, face, air and
clot ing away from all moving parts.
CAUTION: Be careful not to tip t e model
over. Model s ould be placed on a flat and ard
surface.
•S are t e K'NEX experience wit your c ild
and make building wit K'NEX a family fun
adventure.
•Take your time to enjoy t e building process.
Don't rus !
•W ile you’re building make sure you face your
model in t e same direction as t e pictures
s ow in t e instructions.
•Be sure to install batteries into t e motor before
you start building your motorized models.
•Product and colors may vary.
!
BATTERY INFORMATION
Cautio : To Avoid Battery Leakage
•Be sure to insert t e batteries correctly and always follow t e toy
and battery manufacturers’ instructions.
•Do not mix old and new batteries or alkaline, standard (carbon-
zinc) or rec argeable (nickel-cadmium) batteries. Only batteries
of t e same or equivalent type recommended s ould be used.
•Always remove weak or dead batteries from t e product; do not
s ort-circuit supply terminals.
•Insert batteries wit correct polarity (+/-) as s own.
Importa t Tips:
•Alkaline batteries AA (LR6) are recommended.
•Rec argeable batteries are not recommended.
•Remove rec argeable batteries from toy before c arging; t ey
must be c arged only under adult supervision.
•Non-rec argeable batteries must not be rec arged.
•Keep components free of dust; do not immerse or use in water.
•Do not dispose of batteries in a fire; t ey could leak
or explode and cause injury.
•Remove all batteries if t e toy will not be used for a long period of time.
•Do not put Rods smaller t an 2 inc es in any openings of t e
motor; t ey will damage t e motor, and cannot be removed.
How to I sert a d
Remove Batteries:
•Use a small P illips ead
screwdriver to loosen t e
screw. Insert 2 fres AA
batteries (LR6) into t e
compartment wit t e
correct polarity (+/-) as
s own ere.
+
-

Gears:
To engage the Gears, push the tan Lock into the
holes of the Gear. Note the postion of the Gears
and the direction of the teeth. Make sure the
Gears mesh.
BUILDING BASICS
Getting Started:
To begin your model, find the and follow the
numbers. Each piece has its own shape and color.
Just look at the pictures, find the pieces in your
set that match and then connect them together.
Try to face your model in the same direction as
the instructions while you build. Faded colors
show you this section is already built. You’ll want
to connect the new section to the place where the
arrows are pointing.
1 3
-
Connectors:
There are blue and gray Connectors with special
long slots. They slide together as you see in the
pictures. Push these parts together until you hear
a “click.”
Spacers:
There are places in your model where you need to
add blue and silver Spacers. Be sure to use the
right color and count them carefully.
Parts Count:
Before you start building, be sure to compare the
parts in your set with the parts listed here.
If anything is missing, call or write to us using the
information on the back cover. We’re here to help
1
1
2
4
3

4
1 3
-
1
2
3

5
1 5
-
5
4
1 3
-
x3
4
4
4

6
1 6
-
6
1 5
-

7
7
x2
x2
7

8
x2
x3
x2
8
9
8

9
7 13
-
Did you install 2 AA (or LR6) batteries
in the Motor?
Est-ce que tu as installé 2 piles AA (ou LR6) dans le moteur ?
¿Instalaste dos pilas AA (o LR6) en el Motor?
Heb je 2 AA (of LR6) batterijen gestoken in de motor?
Hai installato 2 batterie AA (o LR6) nel motore?
Foram instaladas as pilhas 2 AA (ou LR6) no Motor?
Heb je er 2 AA (of LR6) batterijen ingestoken?
Installerade du 2AA (eller LR6) batterier?
Har du sat 2 AA (eller LR6) batterier i?
Har du installert 2AA (eller LR6) batteriene?
Oletko asentanut 2AA (tai LR6) -paristot?
FI
NO
DA
SV
NL
PT
IT
DE
ES
FR
13
10
11
12
8
7
7
8
9
9 10
-

10
1 14
-
14
1 6
-
7 13
-