Kodak Luma 75 User manual

Luma 75 Pocket Portable Projector Support
Getting Started
1. Charge the Projector
•Connect the adapter to the micro USB port of the projector, using the included power
cord.
•Plug the adapter into an outlet or other power source.
•You may now use the projector .
•While plugged in, the projector's battery will automatically charge.
It is recommended that you allow the projector to charge for at least 4 hours before using it in
battery mode for the first time.
2. Turn on the Projector
Press and hold the power button for 5 seconds to turn on the projector.
3. Adjust Screen Size
The screen size will increase or decrease as the projector is brought closer or further from the
wall.
4. Adjust the Focus Wheel
Open a still image and carefully rotate the focus wheel until the image is clear.

5. Connect to an External Device
Your projector can be connected to a variety of external devices using the included HDMI®
cable. Compatible devices include laptops, smartphones, tablets, gaming devices, and more.
•Connect one end of the HDMI® cable to the projector.
•Connect the other end of the HDMI® cable to the external device.
NOTE: Some devices may require an adapter in order to connect to the projector. Check the
table in the online user manual if using a device that is not HDMI® compatible.
6. Insert MicroSD™ Card or USB Drive
Slide the microSD™ card into the microSD™ card slot until it clicks into place. If using a USB
drive, insert it into the USB input.
Using Your Projector
1. Turn on the Projector
Press and hold the power button to turn on the projector.
2. Playing a Video File

•After turning on the projector, you will be prompted to select either Movies or Images.
•Tap the Confirm button to gain access to the control panel, then use the confirm button to
select Movie.
•You will then be prompted to select either USB or MicroSD™. Use the buttons to
highlight the format you wish to access. Then tap the confirm button to select.
•Use the buttons to cycle through the list of files. Select the file you wish to play with the
confirm button.
3. Video Controls
Before you can use the control panel, you must always tap the confirm button to make it appear
first.
•Pause: Tap the confirm button.
•Fast Forward: Tap the button. Each tap will increase the speed by x2, x4, x8, and x16.
•Rewind: Tap the button. Each tap will increase the speed by x2, x4, x8, and x16.
•Exit: Tap the button to return to the video file list. Tap this button again to return to the
main menu.
•Volume Control: Tap the button. Then use the plus and minus buttons to increase or
decrease the volume.
4. Playing a Photo File
•After turning on the projector, you will be prompted to select either Movies or Images.
•Tap the confirm button to gain access to the control panel.
•Use the forward button to highlight the Images option. Then use the confirm button to
select Images.
•You will then be prompted to select either USB or MicroSD™. Use the navigation
buttons to highlight the format you wish to access. Then tap the confirm button to select.
•Use the left and right buttons to cycle through the list of files. Select the file you wish to
play with the confirm button.
5. Photo Controls

When playing a photo file, the projector will automatically play in order.
•Pause Slideshow: Tap the confirm button.
•Resume Slideshow: Tap the confirm button.
•Play Next Image: Tap the confirm button.
•Play Previous Image: Tap the confirm button.
Firmware Update
•1. Download this zip file.
2. Unzip and copy the file MERGE.bin to a USB drive (note: USB drive
must be empty and formatted FAT32).
3. Before powering on projector, insert USB drive.
4. Power on projector. Make sure not to remove the USB as the projector
is booting.
5. Projector should now boot up with most current firmware.
•