Kohler 72842T-4ND User manual

1279538-AN2-A 1
BEFORE YOU BEGIN
All information is based on the latest product information available at the time of publication. Kohler Co. reserves
the right to make changes in product characteristics, packaging, or availability at any time without notice.
Please leave these instructions for the consumer. They contain important information.
NOTES:
1. Flush the water supply pipes thoroughly to remove debris.
2. An in line water filter must be used with this product.
3. If possible, install this basin mixer before installing the basin.
4. Inspect the supply tubing for damage and leakage. Replace and maintain as necessary.
5. Observe local plumbing codes.
6. Shut off the water supplies to the fitting.
7. All installations should comply with the relevant requirements of AS/NZS 3500 and AS/NZS 6400.
HANDLE OPERATION
Operation for open and close, hot and cold water as shown below.
INSTALLATION INSTRUCTIONS
72842T-4ND Single Lever Basin Mixer
72843T-4ND Single Lever Tall Basin Mixer
STANCE
ROUGH-IN DIMENSIONS
125
12°
Ø30~Ø37
Max. 40
85
195565
G1/2˝
164
12°
Ø30~Ø37
Max. 40
200
310
450
G1/2˝
54
45°
45°
Hot Cold
Close
Open
72843T-4ND72842T-4ND

1279538-AN2-A 2 1279538-AN2-A 3
INSTALLATION CHECKOUT
Ensure that all coupling nuts tightened. Ensure that
the handle is in the off position.
Turn on the drain and main water supply, and check
for leaks. Repair as needed.
Remove the aerator(8) with the key(9) provided. Turn
on mixer handle. Run hot and cold water through
spout for about one minute to remove any debris.
Check for leaks at this time. Remove any debris from
the aerator assembly. Shut off the mixer. Reinstall the
aerator assembly.
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
INSTALLATION
How to Install the Basin Mixer
Screw the stud(1) to the thread hole on the bottom of
faucet body(4). Put the washer(2) into the bottom of
faucet body through the flexible hoses(3) and the
stud. Insert hoses and stud into the hole of basin.
Position the faucet on the basin. From underside of
the basin, fit the washer(5) and washer(6) on the stud.
Secure the mixer by tightening nut(7).
Attach the hoses to water supplies. The hose with
blue dot connects to cold water.
1
4
2
5
6
7
3
8
9
72842T-4ND Single Lever Basin Mixer
72843T-4ND Single Lever Tall Basin Mixer
SERVICE PARTS
**Color code must be specified when ordering
STANCE
1231663**
1041450
1231661**
1088909
1100166**
1233281
871568
1177299
870721
1278507 1278507
836664
1176148
1231665