Kolibri Signature User manual
2019 Kolibri USAKB-052019
Kolibri Signature has been developed to count up to 1,200 bills per minute, which makes it one of the fastest
top loading bill counters on the market. Therefore, to avoid jamming, misfeeding or other errors, it’s extremely
important to use the proper bill loading method. For better results, it’s also recommended to not count more
than 200 bills at a time.
Kolibri recommends the loading technique as described below:
1. Adjust the bill guides to a size slightly wider (0.10” on each side) than the width of the bills in the stack
(all US dollar denomination are the same size).
2. Correct or remove the bills if they are severely wrinkled, damaged or folded.
3. Square the stack as shown below:
Bill Loading Procedure
Signature
2019 Kolibri USAKB-052019
4. Place the bill stack flat on the hopper shown below:
Avoid counting bills that are wet, excessively dirty, soiled, folded, curled or with foreign material like clips,
bands, etc. Bills such as these can cause the machine to malfunction.
If, after using the recommended bill loading method, this does not resolve the issue, please see the
support section on the Kolibri USA website at www.KolibriUSA.com, or contact Kolibri Support at
Stack of bills
Bill Loading Procedure
Signature
Other manuals for Signature
3
Table of contents
Other Kolibri Banknote Counter manuals
