Kolpin Matrix Seat Bag Instruction Manual

Kolpin Matrix Seat Bag:
Assembly and Installation on Polaris Sportsman 570 & Sportsman ETX
Assembly Steps:
1. For the left side, first
locate the five velcro
straps; one on the side
bag (labeled in picture as
L1), four on the middle
bag (labeled in picture as
M1, M2, M3, M4)
Notes:
•Direction is indicated
when sitting on ATV
facing towards the front.
•Blue masking tape is used
to identify straps for
assembly and installation.
The bag will not come
with labeled straps.
Towards front
of ATV
L1
M1
M2
M3
M4
1

2
Assembly (cont’d):
2. Attach the side
bag velcro strap
thru the loop
on the middle
bag as shown
in the picture
(labeled L1)

3
Assembly (cont’d):
3. Attach the middle
bag velcro straps
that are located
underneath the
backrest pad
(labeled M1, M2 in
the picture) thru the
loops on the side
bag.

4
Assembly (cont’d):
4. Attach the middle
bag velcro straps
that are located on
backside of bag
(labeled M3, M4 in
picture) thru the
loops on the side
bag.

5
Assembly (cont’d)
5. Repeat the
same steps for
the right side
of the bag.
Once
assembled,
the bag will
then look as
shown in
picture.
Towards front
of ATV

6
Installation steps:
1. Locate the buckle straps on the underside of bag (labeled as L1, L2, L3,
L4, M1, M2, M3, M4, M5, M6, M7, R1, R2, R3, R4 in picture). These
straps can be used to secure bag to vehicle rack.
M4
M3
M1
M2
M5
L3
L2
L1
L4
R3
R2
R1
R4
M7
M6

7
Installation (cont’d):
2. Place bag on rear rack as
shown in the picture to
the right.
Installation (cont’d):
3. Feed the left side bag
strap thru the rack grab
bar and buckle as shown
in picture to the left.
Slight adjustments of the
straps will be needed.

8
Installation (cont’d):
4. Feed the two left side
rear bag straps thru the
rack grab bar and buckle
as shown in the picture
below.
Installation (cont’d):
5. Feed the two right side
rear bag straps thru the
rack grab bar and buckle
as shown in the picture
above.

9
Installation (cont’d):
6. Feed the right side bag
strap thru the rack grab
bar and buckle as shown
in picture to the right.
Slight adjustments of the
straps will be needed.
Installation (cont’d):
7. Feed the front right bag
strap thru the rack grab
bar and buckle as shown
in the left.

10
Installation (cont’d):
8. Feed the two middle bag
straps that are under the
seat pad thru the rack
grab bar and buckle as
shown in picture to the
right. Slight adjustments
of the straps will be
needed.
Installation (cont’d):
9. Feed the front left bag
strap thru the rack grab
bar and buckle as shown
in the left.

Installation (cont’d):
10. The Matrix Seat Bag
should now be secured
to the vehicle rear rack
with ten buckle straps.
Slight strap adjustments
will be needed to tighten
bag fit to vehicle.
Looking for ATV accessories & parts? Rely on Kolpin for quality and long-lasting products.