Konexx Konference Konnector User manual

Local: 863-614-1900 Toll Free: 866-770-4930 Fax: [phone]
E-mail: [e-mail] or Skype Us
TelephonemanOfAmerica.com or shop.telephonemanofamerica.com
TELEPHONE MAN OF AMERICA
Earning Your Business Every Step of the Way!
Specializing in Telecom Equipment of all Brands, Carrier Services, Technician
Services, Maintenance Agreements and Purchasing Excess Telecom Equipment!
I will always do my best to match or beat any competitors bid!

KONEXX Konference Konnector
OPERATING INSTRUCTIONS - IMPORTANT - PLEASE READ CAREFULLY
The KONEXX Konference Konnector connection device is used to connect a conferencing phone
to digital or multi-line phone systems through the handset port of the digital or multi-line telephone
instrument.
Figure 1: Typical Installation
1. Unplug the coiled handset cord from the telephone instrument.
2. Plug the short cord on the KONEXX into the handset jack on the telephone base (from which you just removed the
coiled cord).
3. Plug the coiled cord from the handset into the KONEXX jack labeled "HANDSET".
4. Plug the telephone cord from the conference phone outlet labeled "Line" or "Wall" into the KONEXX jack labeled
"DATA PORT".
5. Plug the AC adapter into the power jack on the end of the KONEXX product. The KONEXX Konference Konnector will
not operate without the power supply.
6. Place the switch on the KONEXX to the #3 position. Your telephone can now be used in the normal manner. TRY
YOUR TELEPHONE.
7. The "OUTPUT LEVEL" switch on the KONEXX product sets the signal level from your conference phone to the digital
telephone and this switch must be set for the type of telephone instrument you are using. The "#2" position is the
highest level and is used with telephones employing carbon microphones. Many of the older hotel/motel telephones
are of this type, as are the majority of older standard telephones found in the home. When the "OUTPUT LEVEL"
switch is set in a position where the level is too high, there will be feedback to the handset earpiece or conference
phone. Feedback may appear as a buzz, tone or even a loud squeal. If feedback is present, move the "OUTPUT
LEVEL" switch to the next lower setting until the feedback is eliminated. "OUTPUT LEVEL" sequence is 2-3-1-4 in
descending order.

8. OPERATING WITH KONEXX KONFERENCE KONNECTOR:
A. Prepare your conference phone for operation, set up to the point where all you must do is press the
key to take conference phone "off hook".
B. Using the digital or multiline telephone set, establish your call (make or answer the call).
C. Once the call is established on the digital or multiline telephone set, take the conference phone “off-
hook” (turn it on).
!Leave your handset OFF THE CRADLE while communicating on the conference phone.
9. OPERATIONAL HINTS:
A. Make sure your conference phone is taken "OFF HOOK" (turned on) once all parties are connected
in the call.
B. Make sure that your conference phone is in the "TONE DIAL" mode, not in the pulse dial mode.
C. Make sure the telephone handset has been LIFTED OUT OF THE CRADLE.
D. Remember that the KONEXX Konference Konnector must have the AC adapter connected in order
to operate.
E. The KONEXX Konference Konnector will not operate with telephones which have the dialer in the
handset, such as Princess or Trimline phones. The electronics with which the Konference Konnector
interacts are not accessible in these telephones.
F. Remember that the KONEXX Konference Konnector disconnects the telephone handset microphone when the
conference phone is "off-hook".
DIRECT QUESTIONS/SERVICE
INQUIRIES TO:
Konexx, Unlimited Systems Corp., Inc.
5550 Oberlin Drive
San Diego, CA 92121
Phone [phone]
Fax [phone]
[e-mail]

OUTPUT LEVEL SETTING CHART
MANUFACTURER MODEL SWITCH
SETTING
Alcatel None
Specified 3
Avaya
Lucent
or
AT&T
Definity
Destiny
Dimension
Horizon
ISDN
Infinity
Legend
Merlin
Merlin II
Partner
Spirit
System 25
System 75
System 85
3
3
2 or 3
2
3
3
3
3
3
3
3
3
3
3
Comdial Digitech
Executech
Impact
3
3
3
David Systems None
Specified 3
Eagle None
Specified 2
Ericcson MD110 3
Executone Encore CX
IDS
Model 228
Model 432
Key Systems
3
3
3-See
Note 1
3-See
Note 1
2 or 3
Fujitsu Focus 196
Others
See Note 2
4
MANUFACTURER MODEL SWITCH
SETTING
Harris Lanier 3
Hitachi Digital
Model 200
HCX-5000
1
1
Intecom IBX System 3
Intertel Hitech
MPK-2
Axxess
Others
1
1
3
1
Isoetec Key systems
Digital PBX
3
1
ITT None
Specified 2
Iwatsu Omega
Omega III
Omega IV
2
2 or 3
1 or 4
Kokyo Co. Kanda 1
Lanier EKT - 220
(Elec. Key) 2
Lexar Telex See Note 2
Macrotel None
Specified 4
Mitel Superset
SX-200
2 or 3
3
NEC Determ II
Determ III
Determ IV
Electra
Freedom
Mark II
Others
1 or 4
1 or 4
1
2 or 3
1
1
1
MANUFACTURER MODEL SWITCH
SETTING
Nitsuko Onyx 3
Northcom Premier
(NC-1648) 3
Nortel
Or
Northern
Telecom
Advantage
Focus
Logic One
Meridian
SL1 &
SL100
Meridian 1
Norstar
Unity
Vantage
3
2
3
3
3
3
2 or 3
3
Panasonic KXT series
DBS
Others
3
2 or 3
3
Phillips None
Specified 1 or 4
Premier Digital 1 or 4
Siemens
Rolm Model 120
Model 240
Model 400
Model 600
Others
1 or 4
1 or 4
1 or 4
1 or 4
1 or 4
Other
Siemens Dyad
Dyad Jr.
HCM-600
HCM-200
Hicom
Digital
Saturn
Digit 260
See Note 2
See Note 2
3
3
1
See Note 2

OUTPUT LEVEL SETTING CHART continued
MANUFACTURER MODEL SWITCH
SETTING
Southwestern Bell Freedom
Phone-
Older
Freedom
Phone-
Newer
3
1 or 4
SRX Vision
Phone 2
Tadiran EKT 221
Emerald
Coral I & II
Others
3 - See
Note 1
4
4
3 - See
Note 1
Telrad Model 816
Model 2464
Symphony
Digital
(818)
Others
4
4
4
4
4
TIE Business
Comm
Datastar
DCX
Meritore
Onyx
TC22
EX2260
Ultracom CX
Keyset 9
2
2
2
2
3
2
2
2
2
MANUFACTURER MODEL SWITCH
SETTING
Toshiba EKT 2000
series
EKT 3000
series
EKT6000
series
Perception
Strata
(Key system)
Strata
(Digital)
103 series
2
2
3 or 4
3
2
1 or 3
2 or 3
Trillium Panther
Talkto 616
2 or 3
2
Vodavi Electronic
Key System 3 - See
Note 1
Walker Marathon
Poet
1 or 4
1
Notes:
1. The indicated telephone set may require a custom setting
(performed by Konexx) to optimize the audio level from the
conference phone to the remote parties.
2. The indicated telephone has “Non-Standard” handset wiring, which
requires an adapter cable. Contact Konexx if you have one of these
telephones.