Konica Minolta DK-514 User manual

E-1
DK-514 Desk
INSTALLATION MANUAL
A860-9553-00
Applied Machines: C287/C227
COLOR MFP: 28 ppm/22 ppm
Product Code: A797/A798
Caution:
Lifting the machine in an awkward position or
transporting it in a poorly balanced position could
result in personal injury. When transporting the
machine, assign an adequate number of persons
to the job and ensure that each person can take a
good position of not being excessively loaded
(mass: approx. 20 kg (44-1/16 lb)).
1. Accessory parts
Note:
This manual provides the illustrations of the acces-
sory parts and machine that may be slightly differ-
ent in shape from yours. In that case, instead of
the illustrations, use the appearance of your
machine to follow the installation procedure. This
does not cause any significant change or problem
with the procedure.
Caution:
When removing the Desk from its shipping carton,
do not hold the reinforcement bracket (as a per-
sonal injury or a deformed frame could result).
No. Name Shape Q’ty
1. Leg assy
4
2. Fixing
bracket A
2
3. Fixing
bracket B
1
4. Fixing
bracket C
1
5. Screw
5
6. Installation
manual 1
set
Keep this bag away from babies and
children. Do not use in cribs, beds,
carriages, or playpens.
The thin film may cling to nose and
mouth and prevent breathing. This bag is
not a toy.
Reinforcement bracket

E-2
2. Installation procedures
(1) Turn OFF the power switch and unplug the
power cord from the power outlet.
(2) Remove the protective tape from the Desk.
(3) Hold the part (see the illustration) on the left side
of the machine and the handles on the right side
of the machine, and install the Desk by aligning
with the location pin.
Note:
• When transporting or moving the machines,
assign adequate number of persons.
• When attaching the machine, as the reference
fit the machine with the corner A and B of the
Desk.
When holding the transportation handles,
be careful not to catch your fingers in the
machine.
B
A

E-3
(4) Secure the Desk to the machine by two fixing
brackets A. (Two supplied screws)
(5) Slide out the second and third drawers.
(6) Secure the Desk to the machine by the fixing
bracket B (right) and the fixing bracket C (left).
Fixing bracket B: Two supplied screws.
Fixing bracket C: One supplied screw.
(7) Slide the drawers back into the paper feed cabi-
net and the desk.
(8) Move the machine and Desk to the installation
site. Then, lock the stoppers of the two front
casters to let the Desk sit on the floor.
(9) Attach the four stabilizers (supplied leg assies)
as shown in the illustration.
Note:
If you proceed to install the Finisher FS-534SD/
FS-534 after this installation, do not attach the sta-
bilizer to the left side of the machine.
<Front and left sides>
Use the fixing brackets to secure the unit
to the machine.
Failure to do so and an unlikely event of
leakage could result in an electrical
shock.
To reduce the risk of injury due to
unstable equipment, set stabilizers
before use.

E-4
<Right and rear sides>
Note:
When removing the stabilizers to move the
machine or for other reasons, pull them out while
pushing the lever shown in the illustration.
Lever