Kool Karz Playground KKMB-009 User manual

Important Warning!
Age: 3 Years +
Maximum user
weight :25Kg
1. Not Suitable for children under 36 months.
Choking hazard due to small parts
2. For family and domestic use only
3. Not to be used in traffic
4. Adult assembly required
5. Warning!
Protective equipment should be worn
6. This toy has no brake
7
8. This toy contains batteries that are
non-replaceable
. This toy is unsuitable for children under
3 years due to its maximum speed.
Please keep this manual for future reference as it contains important information.
Before first time use, charge the battery for at least 8-12 hours, no more than 20 hours.
KKMB-009

Below 40OC
DC 12V4.5AH*1
990*550*410 mm
Input: 100-240V,
50-60Hz
3+ years
Under 25Kg
PP
Suitable age:
Load Capacity:
Material:
Charger:
Battery:
Optimum
Product size:
Temperature:
Charging time:
Fuse:
Output: 12V 700mA
8-12 hours,
at most 20 hours
F 5A/6A,Self-resetting
!
2
Page 2
Page 3
Page 4
Page 5-7
Page 8-12
Page 13
Page 14-15
Page 15
Page 16
Operate

6
4
3
35
Remote
control 1
14
The
screw
is on it.
Rearview
mirror
4Rear
Wing 1
Wheels
are the
same
2
15 16
17 18
19
M4X12 6
Instruction
Manual
1
Spanner 2
MP3
Cable
120
2
training
wheel

4
Tools Required
1
1
21
31 41 54
6
Rear Wing 1
1
8
11 M8 nut4 12 M5X35
bolt+M5 nut1set
13
Wheel
cover 4
6
6
20
4
5
11
13
9
2
8
12
7
1
6
Rearview Mirror

Note: both sides of the front wheel
installation method is the same
5
Installation of training wheel
Turn the car upside down.
Remove the M4X12mm screw that has been fixed
to the car body.
Install training wheels.
Then attach with M4X12mm screw.
Install drive motor on the rear axle
Load a wheel on the rear axle
Load a 10# washer on the rear axle
Tighten the nut with plastic wrench
Add plastic wheel cover
Load a 10# washer on the axle
Place front wheel
Load another 10# washer on axle
Tighten the nut with plastic wrench
Add plastic wheel cover

slots on the body of the car.
into seats.
.
Attach the power cable before
use
Note: Power plugs cannot be
operated in reverse
Non-rechargeable batteries can not be recharged.
Batteries can only be recharged under adult supervision.
Rechargeable batteries should be removed from vehicle before charging.
Different types of batteries or old and new batteries can not be combined.
The battery should be placed in the correct polarity.
Exhausted batteries should be removed from vehicle.
Power terminals must not short-circuit.
Dry batteries are not available.
!
3
& Rear Wing
Turn the car upside down.
Remove the M4X12mm screw that has been fixed
to the car body.
Installation of Rear Wing.
Then fixed with M4X12mm screw.
12
6

7
Insert the hook on the mirror into the
holes on both sides of the body.
Plug the cables from steering wheel as
shown
Insert steering wheel onto steering
column
Secure with steering wheel screw and
nut
6.Install the steering wheel
Press the windshield into the body
until installed.
5
Rear view mirrors

Step 1: open the battery cover on the back of the remote control and load into two
AAA(1.5V) batteries; (dry batteries are not available in this product) Step 2: turn off
the main power switch on the car;
Part 3: hold down Forward and Back keys at the same time,when the Speed
display light is flashing, switch the main power switch on the car, the Speed display
red light should stop flashing, pairing success;
Key description: Speed key for speed regulation, each time change a
speed,Speed key one a red light for low speed, two red lights for medium speed,
three red lights for high speed;
a. Press button Forward and the car moves forward;
b. Touch and press Back , the car back;
c. Press button Speed display to adjust the speed of the car.
d. Touch and press Left key . The car turns to the left.
e. Touch and press Right and the car turns to the right;
f. Press the brake key to stop the car, the red lights will all be flashing,
press the brake key to start the car again;
This product may have remote control priority (depending on product
configuration): When the remote control is operated, the pedal
switch of the product is invalid; when the remote control operation is
stopped, the pedal switch of the product can be used.
8

25
!
9
Important! Before using the vehicle for the first time, the battery needs to be charged for 8
to 12 hours, no more than 20 hours. Only an adult can charge the battery.
Finish the car assembly according to the instruction steps in the manual. Ensure the
battery has been plugged in and power is connected.
All screws needed must be attached securely.
The toy has no brake. Always wear a helmet and protective clothing while riding

1. Turn on the power switch first.
2. Forward
●Press the“Forward and Reverse switch” to the “Forward”position.
●Press the pedal.
●The vehicle drives forward.
3. Stop
●Remove foot from the accelerator pedal to stop the car.
4. Reverse
●Press the “Forward and Reverse Switch” to the “Reverse” position.
●Press the pedal.
●The vehicle drives backward.
Always stop vehicle
when changing the
speed or direction to
avoid damage between
the gear box and motor.
10
Pedal
Switch
Power Switch
Forward Reverse Switch
MP3
player
Charging socket

HowToO era幅 Your Vicle
① i nt er f ace : i ns er t USB t er m i n al , co nn ec t au d io s ource , ca n p la y au d io ;
② T F car d J ac k: i ns er t T F car d, ca n p la y au d io ;
③MP3 i nt er f ace : The MP3 Aux li n e ca n b e co nn ec t e d t o o th er d e v ice s a nd p la y au d io ;
④Music switching / volume reduction: touch the button, switch the music, press the button long,
the volume is down;
⑤ Pause button: touch the button, the music stops, touch the button again, the music playing;
⑥Music switching / volume increase : touch the button and switch the music; press the button
long and increase the volume
⑦Mode switching button: touch the button to play MP3 music, then touch the button to play the
music in the USB, and then touch the button to play the music in the USB card.
⑧ Vol t a g e d i sp la y: th e v alue o n th e d i sp la y ca n b e u s e d t o d e t er m i n e w h e th er th e battery is
charged or not.
(6)How to use the steering wheel button
11
Horn button
p
Music button

12
!

!
!
13
1. Find the charging input socket below
the seat.
2. Plug the charger port into the input
socket.
3. Plug the charger plug into a wall outlet.
The battery will begin charging.

14
25

15

16