Kramer VM-2D User manual

VM-2D Quick Start (P/N: 2900-300872QS REV 1)
P/N:
2 9 0 0 - 3 0 0 8 7 2 QS
Rev:
1
Scan for full manual
VM-2D Quick Start Guide
This guide helps you install and use your VM-2D for the first time.
Go to www.kramerav.com/downloads/VM-2D to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
VM-2D 1:2 DVI Distributor
4 Rubber feet
1 Bracket set
1 Power adapter and cord
1 Quick start guide
Step 2: Get to know your VM-2D
#
Feature
Function
1
PROG Mini USB Connector
Connect to a PC to upgrade the firmware (via K-Upload).
2
DVI-I Connector
Connect to a DVI source.
3
EDID Button
Press to read the EDID
4
IN LED
Lights green when an activeinputsignalis detected
5
OUTPUT LEDs (1 to 2)
Lights green when an output device is detected
6
ON LED
Lights green when thedevice receives power
7
OUT 1 DVI-I Connector
Connect to a DVI acceptor.
8
OUT 2 DVI-I Connector
Connect to a DVI acceptor.
9
5V DC Power Connector
5V DC connector for powering the unit.
Step 3: Install the VM-2D
Install VM-2D using one of the following methods:
Attach the rubber feet and place the unit on a flat surface.
Fasten a bracket (included) on each side of the unit and attach it to a flat surface.
For more information go to www.kramerav.com/downloads/VM-2D.
Mount the unit in a rack using an optional RK-3T rack adapter.
Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your VM-2D. For best results, we recommend that you always
use Kramer high-performance cables to connect AV equipment to the VM-2D.

Step 5: Connect the power
Connect the power adapter to the VM-2D and plug the adapter into the mains electricity.
Safety Instructions
Caution:
There are no operator serviceable parts inside the unit
Warning:
Use only the Kramer Electronics power supply that is provided with the unit
Warning:
Disconnect the power and unplug the unit from the wall before installing
See www.KramerAV.com for updated safety information.