Kramer VM-1H4C User manual

VM-1H4C Quick Start
P/N:
2900- 301223QS
Rev:
2
Scan for full manual
VM-1H4C Quick Start Guide
This guide helps you install and use your VM-1H4C for the first time.
Go to www.kramerav.com/downloads/VM-1H4C to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
VM-1H4C 1:4 HDMI Over CAT5 DA
1 Set of rack ears
Power adapter (12V DC)
1 Power cord
IMPORTANT NOTICE!
We highly recommend using only Kramer UNIKAT cables with these products. If using 3rd party shielded CAT-6A cables, both ends of the
shield must be soldered to the connectors for the products to function properly. Do not use any jumpers, unshielded wall plates or mid-
span cable connections. These extenders are not compatible with HDBaseT technologies. Prior to signal extension, ensure that the
extension line cable is lying straight and not coiled.
Step 2: Get to know your VM-1H4C
#
Feature
Function
1
POWER LED
Lights green when the unit receives power
2
REMOTE IR 3.5mm Mini Jack
Connect to the remote IR emitter or receiver
3
INPUT LED
Lights green when the input receives a signal. Flashes when connected but there
is no active signal
4
EDID
READ Button
Press to capture the EDID from the active output
5
SELECT Button
Press to select the output from which to capture the EDID
6
OUTPUT 1~4 LEDs
The relevant LED lights green when that output is connected
7
INPUT HDMI Connector
Connect to the HDMI source
8
RS-232 9-pin D-sub Connector
Connect to an RS-232 controller
9
OUT 1 ~ 4
TP Output RJ-45
Connectors
Connect to the LINE IN RJ-45 connector on the TP receivers
10
12V DC Power Connector
Connect to the +12V DC power adapter. Center pin positive
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.

Step 3: Mount VM-1H4C
Install VM-1H4C using one of the following methods:
•Attach the rubber feet and place the unit on a flat surface.
•Fasten a bracket (included) on each side of the unit and attach it to a flat surface
(see www.kramerav.com/downloads/VM-1H4C).
•Mount the unit in a rack using the recommended rack adapter
(see www.kramerav.com/product/VM-1H4C).
•Ensure that the environment (e.g., maximum ambient temperature &
air flow) is compatible for the device.
•Avoid uneven mechanical loading.
•Appropriate consideration of equipment nameplate ratings should be
used for avoiding overloading of the circuits.
•Reliable earthing of rack-mounted equipment should be maintained.
Step 4: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your VM-1H4C.
To achieve specified extension distances, use the recommended Kramer cables available at www.kramerav.com/product/VM-1H4C.
Using third-party cables may cause damage!
Step 5: Connect power
Connect the power cord to VM-1H4C and plug it into the mains electricity.
Safety Instructions (See www.kramerav.com for updated safety information)
Caution:
•For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the
terminal or in the User Manual.
•There are no operator serviceable parts inside the unit.
Warning:
•Use only the power cord that is supplied with the unit.
•Disconnect the power and unplug the unit from the wall before installing.
Technical Specifications
INPUTS:
1 HDMI connector
1 IR on a 3.5mm mini jack
1 RS-232 on a 9-pin D-sub connector
OUTPUTS:
4 TP on RJ-45 connectors
BANDWIDTH:
Supports up to 4.95Gbps (1.65Gbps per graphic channel)
COMPLIANCE WITH HDMI
STANDARD:
Supports HDMI and HDCP
INDICATOR LEDs:
Power, INPUT, OUTPUT 1, 2, 3 and 4
POWER CONSUMPTION:
12V DC, 2A
OPERATING TEMPERATURE:
0° to +40°C (32° to 104°F)
STORAGE TEMPERATURE:
–40° to +70°C (–40° to 158°F)
HUMIDITY:
10% to 90%, RHL non-condensing
DIMENSIONS:
21.5cm x 16.2cm x 4.4cm (8.5in x 6.38in x 1.7in) W, D, H
WEIGHT:
0.9kg (1.98lbs) approx.
ACCESSORIES:
Power supply
OPTIONS:
HDMI/HDMI male to male cables
Recommended rack adapter (see www.kramerav.com/product/VM-1H4C).