KREAFUNK wiTRAY User manual

wiTRAY
Chic storage solution w. wireless charging
Operation manual
Brugermanual

2
Scan the QR code to nd full manuals and detailed instructions
for all KREAFUNK products,
or enter this url into you web browser:
https://kreafunk.com/customer-service/support/

3
This product is in compliance with the essential requirements and other relevant
provisions of Directive 2014/53/EU.
The declaration of conformity may be consulted at:
www.kreafunk.com/declaration-of-conformity/
SAFETY AND MAINTENANCE INSTRUCTIONS 4
SIKKERHEDS- OG VEDLIGHOLDELSESINSTRUKTIONER 6

4
SAFETY AND MAINTENANCE INSTRUCTIONS
1. Please use adapters with output voltage of 5V=2A/9V=2A or with fast
charging functions when using the product.
2. Do not place any metal object such as iron piece, rings and metal
protection cover on the contact surface during charging.
3. In case of interrupted charging or serious overheating during charging,
it’s probably because the receiving coils of the cell phone is not fully
aligned to the wireless charging coil. Please cool down the cell phone
and re-align it correctly.
4. The product is protected against over current and over voltage. If it is
not used in a proper manner, it will be turned o or will reduce output
power. In such case, please check whether there is any abnormality with
the device or whether it is used improperly.
5. The use ambient temperature shall be maintained at 0~25oC. Please do
not throw the product into water or re or place it in an environment
with excessive high (40oC) or excessive low temperature (-20oC). Keep
children away from the accessories.
6. Please clean the surface of the product with a piece of dry soft cloth and
do not use any chemicals, soap or detergent.
7. If the product is not used or placed properly, it may result in shortened
service life or damage which will not be covered by the warranty and
the manufacturer will not be held liable. Your kind understanding is
appreciated.
8. Fast charging is not available for iPhones in the following
circumstances:
a) The battery level of an iPhone is greater than 60%
b) The iPhone’s IOS version is 11.1.2 or bellow

5
c) The temperature of iPhone is higher than 35-40oC. In such
environment, fast charging is not available and the charging speed is
slow. Therefore, please carry out fast charging in an environment with
appropriate temperature.
9. The product is compatible with 1-4 generation of iWatches with version
5.2 rmware and previous versions.
If you do experience any problems with your product please contact the retailer you
purchased the product from. The retailer will provide you with guidance and if that does
not solve the problem, the retailer will handle the claim directly with KREAFUNK.

6
SIKKERHEDS- OG VEDLIGHOLDELSESINSTRUKTIONER
1. Brug kun strømforsyninger med 5V=2A/9V=2A output eller med hurtig
opladning funktion når du bruger produktet.
2. Placer ikke metal objekter som jern, ringe, nøgler eller visitkort på
opladekontaktaden når der oplades.
3. I tilfælde af afbrudt opladning eller alvorlig overophedning under
opladning, er det oftest på grund af at modtager spolerne på telefonen
ikke er korrekt tilpasset de trådløse oplader spoler i wiTRAY.
4. Dette product er beskyttet mod overstrøm og overspænding. Hvis det
ikke bruges korrekt, bliver det slukket eller reducerer outputeekten. I
sådanne tilfælde skal du kontrollere, om der er nogen unormalitet med
enheden, eller om det bruges forkert.
5. Brugstemperaturen skal holdes på 0~25oC. Kast ikke produktet i vand
eller ild eller anbring det i et miljø med for høj (40oC) eller for lav
temperatur (-20oC). Produktet holdes utilgængeligt for børn.
6. Rengør produktets overade med et stykke tør blød klud, og brug ikke
kemikalier, sæbe eller rengøringsmiddel.
7. Hvis produktet ikke bruges eller placeres korrekt, kan det resultere
i forkortet levetid eller skader, som ikke er dækket af garantien, og
producenten vil ikke blive holdt ansvarlig.
8. Hurtigopladning er ikke tilgængelig for iPhones under følgende
omstændigheder:
a) Batteriets niveau er større end 60%
b) iPhonens IOS-version er 11.1.2 eller under
c) Temperaturen på iPhone er højere end 35-40oC. I sådanne omgivelser
er hurtigopladning ikke tilgængelig, og opladningshastigheden er
langsom. Udfør derfor hurtigopladning i et miljø med passende

7
temperatur.
9. Produktet er kompatibelt med 1-4 generation af iWatches med rmware
version 5.2 og tidligere versioner.
Hvis du oplever nogen problemer med dit produkt, bedes du kontakte den forhandler
du købte produktet hos. Forhandleren vil give dig vejledning og hvis dette ikke løser
problemet, vil forhandleren håndtere kravet direkte med KREAFUNK.

8

9

10
USB-C 5V/2A
9V/2A (MAX)
5W10W
OVERVIEW/OVERSIGT/

11
USB-C 5V/2A
Red Red
ON/OFF/TÆND SLUK

12
ALIGNMENT/JUSTERING

13
Blue

14
Blue

15
Blue
Blue
POWER SOURCE/STRØMKILDE

16
USB-C
5V/2A
9V/2A (MAX)
200 x 95 x 12 (mm)
240g
Qi enabled earphones
Qi enabled Smartphones
X
Z
Y
SPECIFICATIONS/SPECIFIKATIONER

FCC STATEMENT
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference received, including
interference that may cause undesired operation.
Important:
Changes or modications to this product not authorized could void the FCC
compliance and negate your authority to operate the product.
NOTE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.