KT&C KPC-DQ100NHB User manual

Thank you for choosing our high quality camera.
Before attempting to connect or operate, please read and follow
these instructions.
OPERATION MANUAL
M060-DN100-002

CONTENTS
1. Cautions
2. Features
3. Package
4. Overview and function
5. Installation
6. Connection
7. Dimensions
8. Specifications
9. Setup menu operation
• SETUP MENU
• SETUP MODE
• CAMERA ID
• LENS
• SHUTTER
• WHITE BALANCE
• LANGUAGE MODE SETUP
• RESET
10.Function Menu operation
• FUNCTION MENU
• BLC
• AGC
• DAY&NIGHT
• PRIVACY
• MIRROR
• GAMMA
• MOTION
11.Troubleshooting
3

1.Cautions
4
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions;
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio communications.
However, there is no guarantree that interference will not occur in a particular
installation. If this equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Note-
• Reorient or relocate the receiving antena.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
whice the receiver is connected.
• Consult the dealer or an experienced radio / tv technician for helf.
Any changes or modications in construction of this devies
which are not expressly approved by the party responsible
for compliance could void the user's authority to operate the
equipment.
Caution -
1. A regulated DC12V 1.5A power supply is recommended for use with this camera
for the best picture and the most stable operation.
An unregulated power supply can cause damage to the camera.
When unregulated power supply is applied, product warranty will be
out of subject.
2. It is recommended that the camera is used with a monitor that has a CCTV quality
75 video impedance level.
If your monitor is switched to high impedance the n please adjust accordingly.
3. Do not attempt to disassmble the camera to gain access to the internal conponets.
Refer servicing to your dealer.
4. Never face the camera towards the sun or any bright or reective light, which may
cause smear on the picture and possible damage to the CCD.
5. Do not remove the serial sticker for the warranty service.

Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with
separate collection systems)
This marking shown on the product or its literature, indicate that it should not
be disposed with other household wastes at the end of its working life. To
prevent possible harm to the environment or human health from uncontrolled
waste disposal, please separate this from other types of wastes and recycle it
responsibly to promote the sustainable reuse of material resources.
This product should not be mixed with other commercial wastes purchased this
product, or their local government ofce, for details of where and how they can
take item for environmentally safe recycling.
Business users should contact their supplier and check the terms and
conditions of the purchase contract.
Household users should contact either the retailer where they for disposal.
1.Cautions
5

CAUTIONS
1
2.Features
6 7
• 1/3″Sony Super HAD CCDⅡ
• 550TV Lines
• OSD Function
• Digital slow shutter, Manual shutter
• Privacy Zone
• Dual Voltage use DC12V/AC24V
• Motion Detection
• 3-Axis Gimbal
The Se rvic e Vide o Conn ecto r also p rovi des th e inst all er wit h an
easy way of configuring the camera.
• Service Video connector

3. Package
6 7
1 DOME CAMERA
2 VIDEO OUTPUT TEST CABLE
3 OPERATION MANUAL
4 SCREW - 3ea
5 MOUNT GUIDE

4.Overview and function
• CONTROL FUNCTION
(OSD JOYSTICK)
LEFT
UP
RIGHT
DOWN
MENU
• Name (LED Type)
• Name (Standard)
8 9

5. Installation
8 9
NO PART NAME
STANDARD Type LED Type
1Mount Guide
2Housing Botton
3Holder Panning
4Holder Tlit
5Holder Rotate
6Cover Sun Shield Cover LED
7Housing Top
8Cover, Dome
Standard Type
LED Type

6.Connection
10
BNC FEMALE
VIDEO
VIDEO IN
DC 12V POWER SUPPLY
BNC FEMALE
VIDEO
VIDEO IN
DC 12V / AC 2 4V
DUAL POWER SUPPLY
When you install the camera, please glue up the end of cable to
keep it stable in order to protect the camera from the humidity problems.
• DUAL(DC12V/AC24V)
• DC12V

7.Dimensions
11
Ø136.4
45
95.3
Ø100
Unit : mm
50˚ 70˚
65˚
◀ When using a wide angle lens
of 2.6mm, Tilt is not available
over 65°.

8.Specifications
12
Signal Format NTSC PAL
Image Device 1/3″Sony Super HAD CCDⅡ
Scanning System 2:1 Interlace
H.Resolution 550TV Lines
Scanning Frequency H:15.734KHz, V:59.94Hz H:15.625KHz, V:50Hz
Total Pixels 811(H) x 508(V) 795(H) x 596(V)
Effective Pixels 768(H) x 494(V) 752(H) x 582(V)
Electronic Shutter Board Lens 1/60 ~ 1/100,000 sec 1/50 ~ 1/100,000 sec
Varifocal DC Lens 1/60 sec 1/50 sec
AGC Off / On(Gain Adjustable)
Motion Detection Off / On(Area Adjustable & Trace On / Off Selectable)
Privacy Masking Zone 4ea (Mask Off / On)
White Balance ATW / AWB / Manual / Fixed
OSD Available
Language English / Japanese / Chinese / Korean
S/N Ratio More than 48dB(AGC Off)
Gamma r=0.45
Min. Illumination 0.05 Lux / Face Plate
Sync System Internal
Video Output 1.0 Vp-p Composite 75(Ω) unbalanced
Power
Consumption
DC12V DC 12V (±10%) Max110mA
Dual DC 12V (±10%) 160mA
AC 24V (±10%) 1.8W
Operating Temperature -10℃~ +50℃
Storage Temperature -20℃~ +60℃
Humidity Less than 80% RH
Options Dual Power
Weight 343g
Power
Consumption
DC12V DC 12V (±10%) Max 400mA
Dual DC 12V (±10%) 540mA
AC 24V (±10%) 5.5W
Min. Illumination 0 Lux (IR LED ON)
IR LED 30ea
IR LED Half Angle ±22 Degree
IR LED Wavelenght 850nm
IR Beam Range Up to 30M
IR LED Operation On : 1 Lux, Off : 3 Lux
LED TYPE
When you x the focus around 22.0mm in f9.0-22.0mm Varifocal lens, please set short
distance focus approximately 3M and do not set long distance focus
Face Plate : Point at the CCD without obstruction of light from any other material.

9.Setup menu operation
OSD STRUCTURE
• ▲,▼ : Menu up / down
• ◀,▶ : Set-up Key
• ■ : MENU(SELECTION KEY)
SETUP MENU
CAMERA ID • ON • OFF
LENS • MANUAL • VIDEO • DC
SHUTTER • AUTO • FLK • FIXED • MANUAL
WHITE BAL. • ATW • AWB • FIXED • MANUAL
FUNCTION
• BLC • AGC • DAY & NIGHT • PRIVACY
• MIRROR • GAMMA • MOTION
ADJUST • CONTRAST • SHARPNESS
• CB_GAIN • CR_GAIN
LANGUAGE • ENGLISH • KOREAN • CHINESE1 • CHINESE2 • JAPANESE
RESET • YES • NO
EXIT
13

14 15
9.Setup menu operation

14 15
9.Setup menu operation

9.Setup menu operation
16 17

9.Setup menu operation
16 17

10.Function Menu operation
18 19

10.Function Menu operation
18 19

10.Function Menu operation
20 21

10.Function Menu operation
20 21