KT&C KPC-VNW101NHV15 User manual

Thank you for choosing our high quality camera.
Before attempting to connect or operate, please read and follow
these instructions.
OPERATION MANUAL
HIGH RESOLUTION
ARMORED DOME CAMERA
M062-VDW101-002
WDR

CONTENTS
1. Cautions
2. Features
3. Package
4. Overview and function
5. Installation
6. Connection
7. Dimensions
8. Specifications
9. OSD Menu
• MENU DESCRIPTION
• GENERAL STRUCTURE
• OSD FUNCTION DESCRIPTION
- LENS
- EXPOSURE
- WHITE BALANCE
- WDR
- DAY & NIGHT
- IMAGE
- SPECIAL
- CAM TITLE
- LANGUAGE
- SYNC
- COMM ADJ
- PRIVACY
- MOTION DET
- DISPLAY
• FACTORY DEFAULT
• EXIT
10.Communication Protocol
2

1.Cautions
3
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions;
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Note -
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio / tv technician for help.
Any changes or modications in construction of this device
which are not expressly approved by the party responsible
for compliance could void the user's authority to operate the
equipment.
Caution -
1. A regulated DC12V 1.5A power supply is recommended for use with this camera
for the best picture and the most stable operation.
An unregulated power supply can cause damage to the camera.
When unregulated power supply is applied, product warranty will be
out of subject.
2. It is recommended that the camera is used with a monitor that has a CCTV quality
75 video impedance level.
If your monitor is switched to high impedance then please adjust accordingly.
3. Do not attempt to disassemble the camera to gain access to the internal
components. Refer servicing to your dealer.
4. Never face the camera towards the sun or any bright or reective light, which may
cause smear on the picture and possible damage to the CCD.
5. Do not remove the serial sticker for the warranty service.

Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with
separate collection systems)
This marking shown on the product or its literature, indicate that it should not
be disposed with other household wastes at the end of its working life. To
prevent possible harm to the environment or human health from uncontrolled
waste disposal, please separate this from other types of wastes and recycle it
responsibly to promote the sustainable reuse of material resources.
This product should not be mixed with other commercial wastes purchased this
product, or their local government ofce, for details of where and how they can
take item for environmentally safe recycling.
Business users should contact their supplier and check the terms and
conditions of the purchase contract.
Household users should contact either the retailer where they for disposal.
1.Cautions
4

CAUTIONS
1
2.Features
5
• Sony Vertical double-density interline CCD image sensor
• 550TV Lines
• WDR (Wide Dynamic Range), OSD Function
• Digital slow shutter, Manual shutter
• Privacy Zone
• Motion Detection
• IR LED : 30ea, Max 30M
• Manual Pan & Tilt Control for easy installation
- Horizontal 360˚, Pan 360˚, Tilt 140˚
Minute Angle Control ±10˚
• Vandalproof
OPTION
• AC24V / DC12V Dual Voltage
• Fan(standard type)
How WDR makes better image?
WDR allows every detail to be captured accurately even if one
portion is bright while other portions are dark.
(The difference of two portions could be more than 64 time)

2.Features
• 3-Axis Gimbal
The Se r v i c e Vide o C o n n ect o r a l s o prov i d e s t he ins t a l l er wi t h a n
easy way of configuring the camera.
• Service Video connector
Pan Rotation Horizontal RotationTilt Rotation
CAUTION panning the bracket in excess of 3 rotations in one direction may
cause damage to the cable.
6

FEATURES
2
CAUTIONS
1
3. Package
1 ARMORED DOME CAMERA
2 SURFACE MOUNT
3 VIDEO OUTPUT TEST CABLE
4 OPERATION MANUAL
5
SCREW(M4x10) - 4ea
SCREW(5x30) - 4ea
SCREW(M4x40.SUS) - 4ea
L WRENCH - T20
6 MOUNT GUIDE
7

4.Overview and function
8
• Name (Led Type)
• Name (Standard)
• CONTROL FUNCTION
(OSD JOYSTICK)
LEFT
UP
RIGHT
DOWN
MENU

5. Installation
9
Standard TypeLED Type
Mount Guide

5. Installation
10
1. Installation of Flush Mount
2. Installation of Surface Mount
PIPE
PIPE
① Installation of the camera with SURFACE
CASE(using M4x40)
② Installation of the camera with SCREWS
③ Installation of the camera with JUNCTION BOX
① Installation of the camera on the wall
② Installation of the camera on the 3/4” NPT PIPE
③ Installation of the camera on the JUNCTION BOX
Check the safe wire which
should be entirely inserted into camera
housing during locking the dome cover to
maintain Weatherproof condition.
When using the camera
without LEDs take off the rubber.
NOTE

6.Connection
11
When you install the camera, please glue up the end of cable to
keep it stable in order to protect the camera from the humidity problems.
• DUAL(DC12V/AC24V)
• DC12V

7.Dimensions
Unit : mm
45
˚
70
˚
Standard Type LED Type
12
When you x the focus around 22.0mm in f9.0-22.0mm Varifocal lens, please
set short distance focus approximately 3M and do not set long distance focus.
Surface Mount Type
Flush Mount Type
Type A Type B

8.Specifications
Signal Format NTSC PAL
Image Device Sony Vertical double-density interline CCD image sensor
Scanning System 2:1 Interlace
H.Resolution 550TV Lines
Scanning Frequency H:15.734KHz, V:59.94Hz H:15.625KHz, V:50Hz
Total Pixels 811(H) x 508(V) 795(H) x 596(V)
Effective Pixels 768(H) x 494(V) 752(H) x 582(V)
Electronic Shutter 1/60 sec 1/50 sec
Digital Slow Shutter 1 ~ 500 Field
WDR Off / On / AUTO(Level Adjustment)
BLC Off / Bottom / Left / Right / Top / Center
AGC LOW / MID / HIGH
Motion Detection Zone(Whole, Top, Bottom, Center, Left, Right) / Level Adjustable
Privacy Masking Zone 8ea (Mask Off / On)
White Balance ATW / PUSH / PUSH LOOK / USER(R Gain, B Gain)
OSD Built-In
Language English / Chinese / Russian / Spanish / German
S/N Ratio More than 48dB(AGC Off)
Gamma r=0.45
Min. Illumination 1.0 Lux / 30 IRE F2.0
0.001 Lux(DSS)
Sync System Internal
Video Output 1.0 Vp-p Composite 75(Ω) unbalanced
Power
Consumption
DC12V DC 12V ±10%, Less than 210mA
Dual • DC 12V ±10%, Less than 300mA
• AC 24V ±10%, Less than 3.1W
Operating Temperature -10℃ ~ +50℃
Storage Temperature -20℃ ~ +60℃
Operating Humidity 10% ~ 80%
Options Dual Power
Weight • Surface Mount Type A : Approx. 1.38kg / Type B : Approx. 1.1kg
• Flush type : Approx. 730g
IP Rating IP 66 (Weatherproof)
Power
Consumption
DC12V DC 12V ±10%, Less than 550 mA
Dual • DC 12V ±10%, Less than 700 mA
• AC 24V ±10%, Less than 6.8W
Min. Illumination 0 Lux (IR LED ON)
IR LED 30ea
IR LED Half Angle ±22 Degree
IR LED Wavelength 850nm
IR Beam Range Up to 30 Meters
IR LED Operation On : 1 Lux or less, Off : 3 Lux more than
LED TYPE
13

9.OSD Menu
MENU DESCRIPTION
• The best clear image can be obtained color camera with
WDR(Wide Dynamic Range).
• The camera switches lenses automatically depending on the
illumination, which promotes the best possible color images during
the day and black / white image at night.
• The camera function can be controlled by OSD menu.
OSD STRUCTURE
• ▲,▼ : M e n u u p / d o w n
• ◀,▶ : Menu left / right
• ■ : MENU
14 1 5

14 1 5
9.OSD Menu
GENERAL STRUCTURE
SETUP
>LENS [┛]
EXPOSURE [┛]
WHITE BALANCE [┛]
WDR [┛]
DAY&NIGHT [┛]
IMAGE [┛]
SPECIAL [┛]
FACTORY DEFAULT
EXIT
LENS
>LENS TYPE ... DC
LEVEL ... 08
INITIAL
RETURN
EXPOSURE
>SHUTTER ... 1/60
FLICKERLESS ... OFF
AGC ... MID
DSS ... 10x
INITIAL
RETURN
WHITE BALANCE
>WB MODE ... ATW
RED CONT ... ----
BLUE CONT ... ----
PUSH CONT ... ----
INITIAL
RETURN
WDR
>WDR MODE ... OFF
WDR LEVEL ... 08
BLC ... OFF
BLC ZONE ... CENTER
BLC LEVEL ... 04
INITIAL
RETURN

MOTION DET
>MOTION MODE ... OFF
ZONE ... WHOLE
LEVEL ... 03
INITIAL
RETURN
PRIVACY
>ZONE ... 0
MASK ... OFF
POSTION ... [┛]
INITIAL
RETURN
9.OSD Menu
DAY & NIGHT
>D&N MODE ... COLOR
LEVEL ... ----
DWELL TIME ... ----
INITIAL
RETURN
IMAGE
>REVERSE ... NORMAL
SHARPNESS ... 10
FREEZE ... OFF
D-ZOOM .. 1,00x
INITIAL
RETURN
SPECIAL
>CAM TITLE ... 001
LANGUAGE ... ENG
SYNC ... ZNT
COMM ADJ ... [┛]
PRIVAC ... [┛]
MOTION DETECT ... [┛]
DISPLAY ... [┛]
INITIAL
RETURN
CAM TITLE
0123456789ABCDEFGHIJKLMN
OPQRSTUVWXYZ!?*#$%()<>{}
SPACE >> <<BACK
LOCATION ... [┛]
RETURN
DISPLAY
>CAM ID ... OFF
CAM TITLE ... OFF
MOTION ... OFF
INITIAL
RETURN
CAM TITLE
CAMM ADJ
>CAM ID ... 000
BAUDRATE ... 9600
INITIAL
RETURN
>LOCATION ...[+]
WIDTH/HIGHT ...[+]
RETURN
16 1 7

LENS MENU STRUCTURE
EXPOSURE MENU STRUCTURE
9.OSD Menu
16 1 7

WHITE BALANCE MENU STRUCTURE
WDR MENU STRUCTURE
9.OSD Menu
18 1 9

DAY & NIGHT MENU STRUCTURE
IMAGE MENU STRUCTURE
9.OSD Menu
18 1 9

SPECIAL-CAM TITLE
SPECIAL-LANGUAGE
9.OSD Menu
20 2 1