La Crosse Technology 403-3246BR User manual

18” Indoor/Outdoor
Lighted Dial Clock
Model: 403-3246BR
DC: 102020
This product is warranted to be free from defects in material
and workmanship under normal use and service for a period
of 2 years from the date of sale to the customer. Warranty
will not apply to defects resulting from abuse, accidents, or
misuse. If a defect that is covered by this warranty arises
during the warranty period, promptly return the clock
(postage prepaid) with proof of purchase showing the date
the clock was purchased to the following address and such
defects will be repaired, or the products will be replaced at
La Crosse Clock Company option without charge.
La Crosse Clock Company
Warranty Department
2830 South 26th Street.
La Crosse, WI 54601
For Online support, visit:
www.lacrossetechnology.com/support
Warranty & Support
Made in China - Printed in China
WARNING: This product can expose you to chemicals including
styrene, which is known in the State of California to cause cancer.
For more information go to: https://www.p65warnings.ca.gov/
Page 4

• Always purchase the correct size and grade of batteries most suitable for
intended use.
• Clean the battery contacts and also those of your clock prior to battery
installation.
• Ensure the batteries are installed with correct polarity (+ and -).
• Remove batteries from equipment when it is not used for an extended
period of time.
• Promptly remove expired batteries.
• The specs of this wall clock may change without prior notice.
• Improper use or unauthorized opening of housing voids warranty.
Care & Maintenance
• Battery Requirements:
1 “AA” LR6 Alkaline Battery (clock)
4 “D” LR20 Alkaline Batteries (lighted dial)
• Battery Life: 12 months
IMPORTANT: Be sure all batteries are of the same voltage level.
Insert all batteries according to the polarity markings.
Specifications
Power Up
1. Remove battery covers from the back of the clock.
2. Insert 1 fresh “AA” alkaline battery into the Center Battery
Compartment.
3. Rotate the Time Set Wheel to set the time.
4. Insert 4 fresh “D” alkaline batteries into the Lighted Dial
Compartments, and be sure the Lighted Dial Switch is set to
ON.
5. Replace the battery covers and mount in your desired
location.
Note: The quartz movement will keep the clock running
accurately. If the clock does not operate, or steadily loses
time, replace the battery in the Center Battery Compartment.
Lighted Dial
• When switch is ON, the clock illuminates when dark, for up
to 6 hours.
• The light timer will reset once clock is exposed to light.
There is a light sensor between the number 6 and 7 at the
front of the clock.
• If the switch is OFF the clock will not illuminate.
Time Set Wheel
Center Battery
Compartment
Lighted Dial
Compartments
Lighted Dial
ON/OFF Switch
ONOFF
DD
DD
DD
DD
Page 2 Page 3