Lakeland Mills CF1123 User manual

CF1123 & CF1124 CEDAR LOG PORCH SWING
Please check contents before assembly. If any items are missing or damaged, do not take the unit back to
the store. Call 1-800-427-5136 for customer service and we will save you time by correcting any problems
directly for you.
 Read all instructions before starting.
 To start lag screws, hammer into wood about 1/2”
then use wrench to tighten.
 Do not completely tighten any screws until the unit
is fully assembled and setting on a level surface.
 Use a rubber mallet (or a block of wood between
the hammer and the unit) to drive doweled ends
into holes as far as possible.
PORCH SWING COMPONENTS
NOTE: Cracks or Checks in logs are part of the natural beauty of
cedar logs and should not be considered defects.
TOOLS REQUIRED
NOTE:
PORCH SWING HARDWARE
(Shown smaller than actual size)
2 Arms 24” Long 2 Arm Supports
12” Long
Rubber
Mallet or
Block of Wood
& hammer
7/16
Socket
7/16”
# 2
Phillips
Screwdriver
Pencil
or Marker
Tape Measure
Regular
Screwdriver
Install seat end onto seat. Align holes in seat end with
dowels on seat as shown in picture right. Repeat on
other side. Secure with screws perpendicular to dowel.
IMPORTANT: The single hole should be placed toward
the front for the seat. (See figure right).
Ten Screws
Two 3/8” x 5”
Eye Bolts
Four 1/4” x 5”
Lag Screws
Two Barrel
Nuts
Two S Hooks
(Not included or needed when A-Frame is purchased)
Two 3/8”Washers
F r e e O f f e r
or
STEP 1
2 - 21”
Seat Ends
Preassembled Swing Back
Preassembled Swing Seat
2 - Swing
Bars - 45”
Long
S Hooks
packaged
separately
for porch
swing
only
Four 1/4” Washers
Please Note: After you have installed the seat ends onto the
seat secure with (4) 2” screws.