Lamassu Douro User manual
Lamassu Bitcoin Machine
Mounting Instructions
v. 0.1.2
1. Open the machine by unlocking it on the side with the red key. Be sure to stabilize the machine,
as the door is heavy.
2. Open the inner cash box vault with the blue
key.
3. Remove the cashbox by pulling straight out on the green handle.
4. Use the allen wrench provided
with the keyset to remove the
screws on either side of the
cashbox vault. (Screws have been
removed in the image.)
5. These screws hold in a metal
plate. Tilt the top of the plate
towards you, and pull it upwards
and outwards. Note: you may need
to push on the bill validator mouth
as there are two white plastic parts
which can block the metal plate
from being removed.
6. Once the plate is removed, disconnect the
white connector that joins two sets of wires
below the bill validator.
7. You can now slide the entire bill validator
mechanism out of the machine.
8. Below where the validator was, you’ll notice three holes for bolting down the machine, in
addition to the two outside of the vault on right side.
9. You may use the plate provided as a washer in order to protect the machine and the surface you
are mounting it on.
10. Mount screws such that the nuts are contained within the machine for security purposes.
