Press the On/Off button
for more than 5 seconds
If the indicator light flashes and
turns off, the controller works
well with the receiver.
Master
Receiver
Slave
Receiver
15m 15m
15m
Slave
Receiver
Slave
Receiver
One controller can control a lot
of receivers, the number of
receivers is not limited. If you
choose this mode, please follow
step2.
If you want to control the farther
products, you can use master and
salver mode. If you choose this function,
please go on with step2 and step3.
L&S 2.111.0008.01.01.00
B
A
Press the Test Button
1
2
3
Lamp
LED Driver
Receiver
Distributor
1
2
3
4
Connect System
AC Power
1
Match the Receiver to Controller
2
Press the Test Button for more than 5 seconds
12
The Function of Master Receiver
3
If the indicator light flashes
after 5 seconds, the controller
works well with the receiver
Set Master Receiver Function
After 5 seconds, the indicator light
turns off, the function of the Master
Receiver is cancelled.
Cancel Master Receiver Function
2
Memory Function
Notice: Memory function will take effect under the receiver working well at
least 60seconds while rotating the color wheel.
Sleeping Function
The remote will go dormant after 60 seconds of inactivity.
Press any button to reactivate the remote.
Master Receiver Setting Function
Notice: Only one master receiver is allowed in the wireless network.
If the slave receiver needs to be setted as master, it can be setted
according to the “Match the master receiver to transmitter”step and
the original master receiver should be powered on.
!
!
www.ls-light.com
