Landscape Fusion L1440 User manual

ASI 264A HRD 49
Assembly Instructions for L1440, L1441 4’ and 6’ Bench
A
SSEMBLY INSTRUCTIONS
Landscape Brands
211 N. Lindbergh Blvd.
Saint Louis, MO 63141-7809
800-231-1327
Fax: [phone]
E-mail: [e-mail]
Web: www.landscapebrands.com
Assembly Recommendations
To prevent scratching on any of the finished pieces, we recommend assembling the unit on packing material (paper and
cardboard). Do not drag assembled unit on any surface. The assembly is a two-person operation.
Mounting Recommendations
For surface mounted products we recommend the use of stainless steel fasteners.
For inground mounted products follow the assembly instruction recommendations.
Cleaning Recommendations
For cleaning, use mild household cleansers or soap and water. Do not use vinyl cleansers or protectants.
Parts List
1 – Bench
2 – Cast Support Legs
2 – Cross Braces
Hardware Included
4 – 5/16” Bolts
8 – 5/16” Washers
4 – 5/16” Flange Nuts
8 – 3/8” Washers
4 – 3/8” Bolts
4 – 3/8” Flange Nuts
Tools Needed
Ratchet with 1/2" & 9/16” Socket
1/2" & 9/16” Wrench
Level
Bench
Cast
Support Leg
Cross Brace

ASI 264A HRD 49
A
SSEMBLY INSTRUCTIONS
Landscape Brands
211 N. Lindbergh Blvd.
Saint Louis, MO 63141-7809
800-231-1327
Fax: [phone]
E-mail: [email protected]
Web: www.landscapebrands.com
Diagram #1 Diagram #2
Furniture should not be used other than for its intended purpose and should be inspected regularly for loose, missing, or broken
hardware, and general instability. Furniture that is damaged or appears to be unstable should be removed from service and
immediately repaired or replaced. Repairs should be made using only factory authorized parts and methods. 800-231-1327
! WARNING
N
u
t
Flat Washe
r
Bol
t
Diagram #3
Note: Before assembling the bolts to the support legs, it is recommended that a light oil or
petroleum jelly be applied to the bolt threads.
1. Place the bench upside down on packing material, on a level surface.
2. Place the 3/8” washers and bolts through the outside of the casting. See Diagram
#2. Keep the nut and second washer off.
3. Align the support legs holes with the holes in the bench, as shown in Diagram #1.
4. Thread the bolts through the bench holes, adding on a second washer and then a
nut, leaving it finger tight.
5. Add the cross braces to the assembly using the 5/16” bolts. Align the hole on the
tab that sticks out of the support leg and the cross brace on the bench. See
diagram #3
6. Again, put a washer on each side, insert the bolt, and put on the nut, leaving it
finger tight.
7. Turn the bench and support assembly right side up.
8. Level the bench.
9. Tighten all hardware (KEEP THE HEAD OF THE BOLT STATIONARY AND
TIGHTEN THE NUT – THIS WILL HELP TO AVOID SCRATCHING THE
FINISH ON THE SUPPORTS). Retighten the hardware two weeks after initial
assembly.