Lantronix Device Server UDS 10 Installation instructions

Lantronix UDS-10 Programming
DATE:9/15-2003
SOFTWARE VERSION AND BUILD: ALL VERSIONS
DOCUMENT PERTAINS TO: HARDWARE COMMUNICATIONS
Hardware Guide

Lantronix UDS-10 Programming
CONTINENTAL INSTRUMENTS, LLC
345 BAYVIEW DRIVE
AMITYVILLE, NY 11701
[phone]

Continental CICE1995 (Lantronix UDS-10)
Initial Setup
Items needed:
Qty Description
1 Lantronix UDS-10 with power supply.
1 Db25 to Db9 COM Cable
1 IP Address (supplied by End-User)
1 Netmask (supplied by End-User)
1 Gateway IP Address supplied by End-User (If necessary)
1 PC running Windows and HyperTerminal
Programming Steps:
Step 1 - Attach the Com cable from the PC to the db25 connector on the
UDS-10.
Step 2 -Open HyperTerminal (click Start, Programs, Accessories,
Communications, HyperTerminal)
Set your port to the following:

Figure 1- The Com Port properties screen
Step 3 - Press and Hold the “x” key down while attaching the power plug
on the UDS-10.
The following screen should appear:
Figure 2 – The HyperTerminal window
Step 4 - Press “Enter”.
The following screen should appear:
Figure 3 – The Lantronix programming screen

Step 5 - Press “0” to enter the server configuration.
Step 6 - Enter your IP Address
Step 7 - If your network requires you to pass thru a router to access the UDS-10
then Press “Y” to Set Gateway IP Address. Otherwise, hit “Enter”.
Step 8 - If you entered “Y” in the previous step then enter the Gateway IP Address.
Step 9 - Enter the Netmask. The following settings are for “Classfull” Addresses
only. If the company is using “Classless” Addresses then the company will have to
provide you with the amount of bits reserved for “Host”.
If Class A IP Address enter 24
If Class B IP Address enter 16
If Class C IP Address enter 08

Press the “Enter” key until we reach the main menu screen again.
Figure 4 – The Lantronix configuration screen
Step 10 - Press “1” to enter Channel 1 configuration.
Figure 5 - The Channel 1 configuration screen

Step 11 - If we are going to connect the UDS-10 using RS-232, the only change
we need to make to this configuration is “Port No”. It needs to be changed to
“3001”.
If we are going to connect the UDS-10 using RS-422 we also need to change the
“IF Mode” to “4D”.
Press the “Enter” key until we reach the main menu screen again.
Step 12 - Press “9” and “Enter”
Programming is complete!

1