Larson Electronics EPLC2-WPLED-50W-RT User manual

EPLC2-WPLED-50W-RT
Larson Electronics, LLC Phone: [phone] Fax: [phone] www.larsonelectronics.com
1of 2
•Be certain electrical power is OFF before and during installation and maintenance.
•Luminaire must be connected to a wiring system with an equipment-grounding conductor.
To avoid explosion:
•Make sure the supply voltage is within the luminaires’ voltage rating.
•Ensure the marked T rating is less than the ignition temperature of the Hazardous
Atmosphere.
•Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
•Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
For supplyconnections, use wire rated for at least 110°C
Recommendedmounting height is 25-40 feet.
MOUNTING
This fixture offers an adjustable surface mounting system
that allows this fixture to be mounted to any flat surface
including walls and ceilings. A single ½-13 bolt isused to
mount the fixture to the surface. Simply drill a hole in the
desired mounting location, pass the bolt through the
trunnion mount and the hole you drilled, and secure with a
washer and nut.
50W Hazardous Location Wall Pack LED Light - Surface Mount
T5, IP67 - Class I, II, III
Instruction Manual
This explosion proof lightis designed for illumination of industrial locations. It uses the latest in solid
state lighting technology for long life, low maintenance and high efficiency.
The unique design focuses the light where it is needed, giving improved efficiency over a
conventional HIDluminaire.
An internal, universal input, power-factor-corrected switch-mode supplyallowsit to be used from any
nominal100-277V AC 50/60 Hz or 11-25V AC/DC power supply(depending on model) without
any variation in light output.See product label for correct input voltage.
WARNING
To avoidthe risk of fire,explosion or electric shock, thisproduct should be installed, inspected
and maintained by a qualified electricianonly, in accordancewith all applicableelectrical codes.
To avoidelectric shock:

EPLC2-WPLED-50W-RT
Larson Electronics, LLC Phone: [phone] Fax: [phone] www.larsonelectronics.com
2of 2
WIRING (see attached wiring diagram)
This unit comes preconfigured in the selected voltage, beam configuration, and color temperature.
Wire light to the correct voltage. Follow all applicable local, state, and National Electrical Code for the
hazardous area!
MAINTENANCE
Caution: To avoid personal injury, disconnect power to the light and allow the unit to cool
down before performing maintenance.
Warning: No user serviceable parts inside of fixture. Risk of electric shock. Removal of the lens
will void the warranty.
1. Perform visual, mechanical and electrical inspections on a regular basis. We recommend
routine checks to be made on a yearly basis. Frequency of use and environment should
determine this. It is recommended to follow an Electrical Preventive Maintenance Program
as described in NFPA 70B: Recommended practice for Electrical Equipment.
2. The lens should be cleaned periodically as needed to ensure continued photometric
performance. Clean the lens with a damp, non-abrasive, lint-free cloth. If not sufficient, use
mild soap or a liquid cleaner.
3. Inspect the cooking fins on the luminaire to ensure that they are free of any obstructions
or contamination (i.e. excessive dust build-up). Clean with a non-abrasive cloth if
needed.
4. Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
WARRANTY
Should further information not covered by these instructions be required, please contact Larson Electronics at
1-800-369-6671 or [e-mail] for further assistance.
Please visit LarsonElectronics.com for Warranty and Return information.
WARNING: CHECK NAMEPLATE
FOR PROPER VOLTAGE. DAMAGE
FROM IMPROPER VOLTAGE WILL
VOID WARRANTY.