Leafield Environmental Centrum Forecourt User manual

Cleaning Products should be rinsed with clean
water and then washed with a mild detergent
solution using a bristle brush or sponge. Care
should be taken not to apply undue pressure
that may damage labels. Flush clean with water
after washing. Non heated pressure washer can
be used at no closer the 400mm away from the
unit. The Pressure should be no more than 100
Bar.
Tools Chalk, Hammer, drill, 15mm masonry
drill bit, 17mm socket or spanner, lock Key
(if applicable), 25mm Spade Cutter.
PPE Always wear appropriate PPE
equipment and follow safety guidelines.
Installation guide
Centrum Forecourt
LEAFIELD litter products
enter
fax number
Post
Leafield Way
Leafield Industrial Estate
Corsham, Wiltshire
SN13 9UD
Telephone
01225 816500
Fax
01225 816501
Email
[e-mail]
Website
www.leafield-environmental.com
Ballast filling
From inside the bin remove the cap Place the bin onto the floor on its back. Feed 20kg of gravel into the ballast hole.
Gravel dimension - 6.5 - 15 mm (individual partical
size).
1 32
Quality Standards All Leafield Environmental
products are certificated to BS EN ISO

Place the bin over the holes and insert the fixing
bolts into each hole.
2
Drill 4 x15mm holes in the ground to a depth
of 100mm to accommodate the bolt length
and remove debris from holes.
enter
fax number
Post
Leafield Way
Leafield Industrial Estate
Corsham, Wiltshire
SN13 9UD
Telephone
01225 816500
Fax
01225 816501
Email
[e-mail]
Website
www.leafield-environmental.com
1
Marking out holes for ground fixing
5
1 32
Position the body in the required location and
orientation ensuring that the unit is situated on
a flat level surface.
Using chalk mark the position through the four
holes in the bin base onto the ground below.
Move the bin to one side and clearly mark the
ground in the four hole positions with a cross.
As the gravel collects in the mouth of the bal-
last filling aperture, lift the top of the unit 90
degrees allowing the gravel to slide down to the
base of the unit. Repeat until full.
Stand the unit back upright.
6
Replace the Cap. Position the body in the required
location and orientation ensuring that the unit is
situated on a flat level surface.
4
Ballast filling
Drilling holes and secure into place
Using a 17mm spanner or socket tighten the
bolts to 22.0Nm torque when fitting the unit
onto a concrete surface.
3

2
Stanchion Fixing
3
enter
fax number
Post
Leafield Way
Leafield Industrial Estate
Corsham, Wiltshire
SN13 9UD
Telephone
01225 816500
Fax
01225 816501
Email
[email protected]
Website
www.leafield-environmental.com
1
If required drill out the stanchion securing holes
situated at the back of the bin using a 25mm
spade cutter/hole saw.
3
Position the body in the required location and orientation ensuring that the unit is
situated on a flat level surface. Feed an appropriate fixing material from inside the bin
through the holes and secure into place.