Leafield Environmental EnviroHub User manual

Installation guide
EnviroHub
LEAFIELD recycling products
Cleaning Products should be rinsed with
clean water and then washed with a mild
detergent solution using a bristle brush
or sponge. Care should be taken not to
apply undue pressure that may damage
labels. Flush clean with water after
washing. Non heated pressure washer
can be used at no closer the 400mm
away from the unit. The Pressure should
be no more than 100 Bar.
Tools Cross head screw driver
Assembly
12
Post
Leafield Way
Leafield Industrial Estate
Corsham, Wiltshire SN13 9UD
Telephone
01225 816541
Fax
01225 816501
Email
[e-mail]
Website
www.leafield-
environmental.com
Line the body mouldings up using the pre drilled holes as a guide. Taking 1 screw at a time reach in side of
the 100L Envirobin. Tightening each
screw by hand.
PPE Always wear appropriate PPE
equipment and follow safety guidelines.
Quality Standards All Leafield Environmental
products are certificated to BS EN ISO

Post
Leafield Way
Leafield Industrial Estate
Corsham, Wiltshire SN13 9UD
Telephone
01225 816541
Fax
01225 816501
Email
[e-mail]
Website
www.leafield-
environmental.com
34 5
Assembly
With a cross head screw driver fully
tighten screws.
Please note: Do not overtighten.
For those customers who have two side
pods please repeat steps 1, 2 & 3.
Once all of the Screws have been tightened
fit with plastic sacks if required. Replace all
inserts and lids and position bin for use.