4. Operation Panel and Component Instruction
Color Selector Circle
Sync Status Indicator Light
Speed Keys
Mode Keys Brightness Keys
Scene-save Keys
Pause Key
Play Key On/Off button
2/4
Copyright © 2015 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).
LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA
T3 2.4GHz LED RGB Controller
www.ledworldlighting.com|www.ledworld.ca|1.800.387.4081
5. Remote Control Charging Methods
ŸWhen charging, please connect USB cable to the mobile charger or computer with the USB interface.
ŸThe blue indicator light ickers while charging, and turns green means the charging is completed. The remote control can
be chargeable even at the OFF state, on which the indicator light is dark.
ŸNo memory effect in the lithium battery of remote control. Follow the standard charging procedure even for the rst three
times, no need over charge.
ŸWhen Red indicator light ickers, it is low battery indication and need to be charged. Charging in low battery will affect
life of battery.
ŸPlease make sure about 50% battery remaining, the remote control is not good for long time use, and it needs to be
charged at least two or three months, otherwise the capacity of the battery would be decreased or the battery gets
damaged
6. The learning ID method of remote control
ŸTurn on the receiver and remote control
ŸPress “On/Off button” on the T3-5A or “ID learning button” on the T3-CV for 2 seconds, there is a buzzer sound, and do
not release your hand on the button, at the same time press any keys on the remote control(except on/off key), until the
remote control green LED indicator light ashes 3 times(a voice prompt at the same time), release all the keys.
Note: If you have to control many receivers synchronously, each receiver should be learning ID according to the above
steps learning ID.
Learning ID:
Cancelling ID:
ŸTurn on the receiver and remote control
ŸPress “On/Off button” on the T3-5A or “ID learning button” on the T3-CV for 2 seconds, there is a buzzer sound, and do
not release your hand on the button, after 5 seconds press any keys on the remote control(except On/Off key), until the
remote control red LED indicator light ashes 3 times(a voice prompt at the same time), release
Ÿall the keys.
