LEDX Mamba 4000 X-pand User manual
!
Mamba 4 000 X-pand
English
Congratulations on your choice of LEDX Lights headlamp
You have chosen a quality product, developed and manufactured in Sweden
for tough conditions. By using components of the highest quality and that
you have access to our good service, means that our products have a very
long service life and thus a lower burden on the environment. In case of any
problems with the product, please contact LEDX Light's service for mainte-
nance or repair.
The lamp has been developed with a focus on good light, low weight and
flexibility.
Safety instructions
Warning!
The light from the lamp is very strong, avoid looking directly into the lamp or
light with the lamp in your or someone else's eyes. If someone accidentally
shines into the eyes close your eyes and move your head out of the light
cone. Do not use binoculars or other highly focused optical product to view
the light cone.
If for some reason the lamp does not work, do not try to repair the lamp or
battery yourself. Attempting to open the battery yourself is associated with
the risk of fire or explosion. In case of any problems, contact LEDX Light's
service for advice on how to proceed with your particular product.
Heat dissipation:
The lamp can get very hot about + 75 ° C. If the lamp is used stationary out-
doors or indoors, after a few minutes the lamp's power is gradually reduced
to about 50% depending on air circulation and ambient temperature. To be
able to deliver full power, the lamp needs a continuous air circulation around
the heat sinks through movement. Depending on the ambient temperature,
the speed varies, but about 6 km / h can be seen as a guide value at + 20 ° C.
The lamp has a built-in thermostat that prevents the lamp from overheating,
it automatically lowers the power if the temperature should go above about
+ 75 ° C, when the temperature drops the power rises again.
The light beam also becomes very hot, the light from the lens on the lamp is
very concentrated and can reach temperatures of over + 100 ° C up close. Do
not cover the lamp, eg put it in a pocket or bag with the light on, also avoid
lighting flammable objects up close. This may cause fire or other damage.
Important:
Always disconnect the battery when the lamp is not in use, such as during
transport or storage. This is to prevent the lamp from turning on accidentally
and slowly draining the battery. The lamp has a certain consumption, albeit
very low, even when it is switched off with connected to a battery. There is a
risk that the lamp may drain the battery of the remaining capacity and da-
mage or seriously damage the battery.
Water resistance:
The lamp and battery are weatherproof and can withstand all weather condi-
tions and water splashes, but should not be used under water or washed
with a high-pressure cleaner. Meets IP65.
Lamp
Turn on the light
Connect the battery to the lamp,
be sure that the connectors has
the LEDX logo on the same side.
Do not force the connector to-
gether the wrong way, it can
destroy the battery.
Turn on the lamp by a long press on the switch (approx. 1 sec). Switch
between power modes by short presses, switch off the lamp with a long
press. Upon delivery, the lamp is in program mode 5 which has three power
modes and it starts at a low power. The lamp then starts in the power mode
it was set to when it was turned off. If the battery is disconnected, the lamp
will start on low power again next time.
Battery
Li-Ion battery with USB-C charge and battery indicator
Before using the lamp, the battery needs to be charged. Connect the suppli-
ed charger to a 100-240V wall socket and to the USB-C socket on the battery.
Depending on the battery's capacity, charging takes 4-8 hours from an emp-
ty battery. Do not charge the battery at temperatures below + 2 ° C. Do not
store the battery with low charge, if you have 20% - 40% capacity left, you
should charge the battery within a week or so, if you have less than 20% of
the capacity left, the battery must be charged within a couple of days to avo-
id risk of damage. For long-term storage (several months or more) charge
the battery to about 40-60% and store it dry and preferably cool and not
warmer than normal room temperature. Check the charging status every
three months and charge if necessary. Battery power decreases with decrea-
sing temperature, avoid using the battery if the battery temperature is below
-20 ° C.
Do not leave battery in charger over 24 hours. Do not charge the output port.
Do not discharge the input port.
Battery indicator
When the battery is charged, it is indicated
on the LED panel with a gradually flashing
LED, when the battery has 100% charge, all 5
LEDs are lit with a steady light.
When the battery is not connected to the
charger, these LEDs show the remaining ca-
pacity of the battery.
Activate the LED panel with the button next
to the panel.
Antal LED
som lyser
Kapacitet
% ca
5
98-100%
4
80-95%
3
60-80%
2
40-60%
1
20-40%
1 flashing
1-20%
Programming
The lamp can be programmed to adapt to your own wishes: Make 4 quick
presses of the switch to enter the programming mode - the lamp lights up.
Make 1 short press at a time, you get an answer with a blink from the lamp
that tells you which position you are in, e.g. 3 presses with signal between
each press, the lamp then flashes 3 times. When you are done, make a long
press - the light goes out. Test so that you are in the position you want. In
position 1, the lamp lights up directly when it is connected to a power source.
Mode 1 should not be used with LEDX batteries, butMode 1 should not be
used with LEDX batteries, but only with an external power source via LEDX
Light's protection cable.
Mode 1 should not be used with LEDX batteries, butMode 1 should not be
used with LEDX batteries, but only with an external power source via
LEDX Light's protection cable.
Operating time:
The time may vary with the temperature and condition of the battery
When the battery is about to run out of maximum power, the lamp automa-
tically goes down to about 350 lm and continues to light for about 1 hour,
then the light drops to about 120 lm and lights for another about 1 hour.
Backup battery:
About 350lm for 70 minutes, a total of about 120lm for 2.5 hours.
Push
Mode
Power
2%
Power
6%
Power
20%
Power
40%
Power
80%
Power
100%
Blink
1
1
x
1
2
2
x
x
x
2
3
3
x
x
3
4
4
x
x
x
x
x
x
4
5 (default)
5
x
x
x
5
Operation
time at 20°C
125h
45h
12h
30min
6h
45min
3h
45min
2h
30min
Headgear
The headgear is adjusted at the back with Velcro and is easy to adjust, while
the top straps are easily adjusted with a buckle. It is also equipped with seve-
ral attachment points for the cable from the lamp housing and its connector
as well as the cable from the back battery which is threaded through a hob
before it meets the connector from the lamp housing. At the back of the he-
adgear there is a Velcro strap to attach the Backup battery.
Put on the headgear as follows:
Release the lower headband and elastic on the back of the
headgear.!Let the upper elastic attach about half way on the Velcro.
Put on the headgear, pull it down as far
as possible or until it sits comfortably.
Adjust the length of the upper band
until comfortable.
Adjust the lower band so it fits tightly
in the neck.
Specification:
Lamp housing with 4 LED Cree, lighting system X-pand
Weight:
Lamp housing 88 g
Lamp housing with bracket 131 g
Lamp and head stand complete 200 g
Battery (108 Wh) 590 g
Backup battery 30 g
Warranty
A 3-year warranty is provided against manufacturing defects on the Mamba
4 000 as well as on other parts of the system, with the exception of the batte-
ry, where the limitations described below apply.
3 year warranty is provided against manufacturing defects on the battery,
but with a settlement after 1 year of 1/3 and after 2 years with 2/3 of the price
of a new battery.
The guarantee only applies when the lamp is connected to LEDX batteries or
when the lamp is powered by an external direct current source with a maxi-
mum of 12V rated voltage via LEDX protection cable with protection against
temporary overvoltage and short circuit.
This limited warranty applies only to the original purchaser. LEDX Lights gua-
rantees that your product for a period of three (3) years from the date of pur-
chase, will be free from defects in terms of workmanship and materials in
normal use. LEDX Light's warranty under the warranty is also limited to repai-
ring or replacing the product. If the product turns out to be defective during
the warranty period, please contact your place of purchase. Your proof of
purchase must be attached if you return the product or send it in for repair.
Returns or repairs within the warranty are not possible without proof of pur-
chase.
This warranty does not apply if the product has been altered or if it has been
installed, used, repaired or maintained in any way other than in accordance
with LEDX Lights instructions. The guarantee also does not apply if the pro-
duct has been subjected to abnormal physical or electrical use or in the
event of negligence, abuse or accident.
The warranty also does not cover normal wear and tear. LEDX Lights is not
responsible for any consequences or damages that occur when using this
product, either directly or indirectly. Under no circumstances will LEDX
Light's liability exceed the amount you paid for the product.
Some jurisdictions do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply
without exception.
The item you buy from us must be faultless when you receive it. Should your
product have any defects, it should be reported to us within 14 days of re-
ceiving the product.
As a consumer, you have the right by law to complain for up to three years
from the purchase, but within a reasonable time (two months) from the time
the fault was discovered.
also attach a copy of your order or receipt, a brief description of the reason
for the complaint, a picture of the damage if this is possible and your contact
information (postal address, telephone number and e-mail address).
Never leave a battery discharged or with a little charge, be sure to charge
the battery as soon as possible. A battery that is left uncharged for a long
time risks being destroyed and can then not be recharged.
Table of contents
Other LEDX Headlamp manuals
