LEGRAND NME1250AP User manual

NME1250AP
Non etallic Wireless Access Point
Mounting Enclosure
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: ED1327R1 – Updated July 2010
Legrand/Wiremold electrical systems conform to and s ould be
properly grounded in compliance wit requirements of t e current
National Electrical Code or codes administered by local aut orities.
All electrical products may present a possible s ock or fire
azard if improperly installed or used. Legrand/Wiremold electrical
products may bear t e mark of a Nationally Recognized Testing
Laboratory (NRTL) and s ould be installed in conformance wit current
local and/or t e National Electrical Code.
IMPORTANT: Please read all instructions
before beginning.
CAUTION: To reduce the risk of electrical shock, always disconnect the network lines before servicing or disasse bling this equip ent.
Step 1 Step 2
Raceway
Access Point
Open
Step 3 Trim around opening. Step 4
#10 Screw (Included)
Knife (Not included)
#10 Wall Anchor
(Included)

Wire old
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX [phone] • Outside U.S.: 860-233-6251
Canada:
570 Applewood Crescent • Vaug an, Ontario L4K 4B4
1-800-723-5175 • FAX [phone]
ED1327R1 0710
© Copyrig t 2010 Legrand/Wiremold All Rig ts Reserved
Step 5
NOTE: Wireless Access Device not included.
Mount Screws
Step 6 Step 7
Secure unit closed with
supplied key lock or #6 screw
Close
Hook and Loop Straps
for other routers
Cisco®Router