LEGRAND HPM LDL90TRIWE User manual

Tri-Colour LED Downlights
Instruction Manual
Cat. No: LDL90TRIWE, LDL90TRIPS
1Specifications
Cat. No. LDL90TRIWE LDL90TRIPS
Fascia colour White Polished silver
Nominal Supply Voltage 230 - 240V a.c. 50Hz
Input Power 7W
Power Factor 0.95
Colour Rendering Index (CRI) 80+
Beam Angle 105o
Ambient test Temperature ta: 25o C
Ceiling Cut out size Ø 90mm
Fascia size Ø113mm
Depth into ceiling 61mm
Lifespan (@25°C ambient free air) 35,000hrs
Dimming Yes (with trailing edge dimmer only)
Insulation Rating IC-4 & IC-F
IP Rating IP44*
Length of Power Cord 1m
2 Installation
1. Cut out a hole in the ceiling. Refer to“Ceiling Cut out Size”in the
specications section for the cut out size.
2. Set the Colour temperature. (refer to next section)
3. Connect mains cable.
4. Remove clear plastic protective cover from switch.
5. Fold back spring clips and insert into cut out hole.
Class II construction
Dimmable
IC - 4 Insulation Rating
IC - F Insulation Rating
IC-F
ABUTTED &
COVERED
3 Colour temperature select
Set the selector switch in the desired colour temperature.
LDL90TRIWE & LDL90TRIPS
Colour Temperature Lumens Output Efficacy
3000K nominal 750lm 105lm/W
4000K nominal 850lm 120lm/W
5000K nominal 850lm 120lm/W
Warm Cool
Natural
LDL90TRIWE
LIGHT COLOUR VS LEMENS OUTPUT
*IP rating: Front face when installed as per instructions.

5
4
Insulation Rating
LED Downlight lamp life
Warranty
Legrand warrants this product for a period of 3 years from the date of purchase.
These goods come with guarantees that cannot be excluded under the Australian
and New Zealand Consumer Laws. You are entitled to a replacement or a refund for
a major failure and for compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired if the goods fail to be of
acceptable quality and the failure does not amount to a major failure.
See the Warranty card enclosed with this product for further details.
Customer Service
For all Customer Service and Technical Support
please call Monday to Friday during business hours.
LE11863AAA 08/2019
Product Notes
1. This product must be installed and used as per these instructions. 2. An IP rating of IP44 is generally considered suitable for external walls with supplementary
protection such as overhanging eaves. 3.This product has been designed to operate in ambient temperatures 0°C to 25°C, occasionally reaching 35°C. 4. This
product contains no serviceable parts and no attempt should be made to repair this product. If the product is faulty it should be discarded. 5. This product is not
suitable for installation in hazardous and/or corrosive areas. 6. This product is not suitable for marine environments such as areas subject to salt spray and/or
mist. 7. Electrical installations periodically receive transient over voltages. This product has been designed to minimise the eect of such voltages on connected
equipment. It may not give full protection for extreme over-voltage transients such as those resulting from a close lighting strike. 8. Extended exposure to UV
rays (such as exposure to direct sunlight) may cause discolouration of this product. 9. The material in this product may vary in colour from batch to batch. Colour
matching from one batch to another cannot be guaranteed. 10. Lamp life is an average gure only and may be reduced by frequent switching.11. HPM Legrand
reserves the right to modify the specication of this product at any time. 12. This product utilises intellectual property in the form of registered designs, trademarks,
and/or patents. Such intellectual property remains the property of Legrand in all cases.
Legrand Australia
1300 369 777
www.hpm.com.au
Legrand New Zealand
0800 476 009
www.hpm.co.nz
ABN: 31 000 102 661
LDL90TRIWE, LDL90TRIPS
Cat. No. DOWNLIGHTS QTY PER DIMMER DIMMING RANGE
Legrand EM400A3P, AR400A3P 12 max 1% - 95%
Legrand EM400A2P 12 max 9% - 90%
Legrand EM400T, AR400T 12 max 7% - 97%
HPM 400T 12 max 7% - 97%
Legrand EM250T 8 max 5% - 95%
HPM 250T 8 max 5% - 95%
HPM 700T 21 max 17% - 99%
HPM1000T 30 max 20% - 96%
This series of downlights has achieved an IC-4 and IC-F insulation rating in accordance with AS/NZS 60598.2.2.
A type IC-4 and IC-F luminaire can be installed with building insulation material that can safely be exposed continuously to temperatures up to 90°C.
Such insulation can cover and abut the side of the luminaire.
Refer to diagram shown on the right for clarication.
SCB - Side Clearance to Building element: Minimum distance between the side of the recessed luminaire and any building element.
HCB - Height Clearance to Building element: Minimum distance between the top of the recessed luminaire and any building element above it.
No clearance is required from structural members and buildings elements. (SCB & HCB =
Note: Not suitable for use with loose - ll insulation.
If installed in accordance with the IC-4 and IC-F rating,
insulation shall have a minimum temperature rating of 90°C.
Joist
Combustible building element above fitting
Thermal Insulation Joist
SCB = 0mm
HCB = 0mm
Thermal Insulation abutting and
covering the fixture
6Dimming
This series of downlights are dimmable with trailing edge dimmers only. We recommend the following dimmers only.
Rated Average Lamp LED Life @ 25oC when installed with the
default insulation clearances specied by AS/NZS 3000
Rated Average Lamp LED Life @ 25oC when installed with the
thermal insulation abutting and covering the xture in accordance
with the IC-4 and IC- F rating specied in AS/NZS 60598.2.2
35,000h 20,000h
Note: This from of installation complies with the Wiring Rules AS/NZS 3000 requirement for recessed downlights, clause 4.5.2.3.1 (i).
I nstalled with
No Thermal
Insulation