Leica LID Module 1.0 User manual

Leica RFID
„LID Module 1.0“
Instructions for use
This Statement has to printed in the User Manuel of the End-Product
Leica Microsystems CMS GmbH. Instructions for use, 11XXXXXX, Revision 1.0, 2015-06-15

Contents
2
1. General .......................................................... 4
1.1 Product Description .................................... 4
1.2 Specifications LID Module 1.0 ................... 4
1.3 Specifications RFID Tag D6.7 special ....... 4
1.4 FCC / IC Compliance .................................... 5
Contents

1. General
3
1. General
1.1 Product Description
This microscope contains the RFID module „LID
Module 1.0“.
It recognizes the used filter cubes in the fluotur-
ret.
The different filter cubes are equipped with cor-
responding passive tags (Type D6.7 special).
During initialization phase of the turret, these
tags are read by the LID Module 1.0.
The tags cannot be written or modified by the LID
Module 1.0.
1.2 Specifications LID Module 1.0
Supply Voltage 5V
Dimensions 36 x 25 x 9.8 mm
RFID Protocol ISO 15693
Transmit frequncy 13,56 MHz
Operating temperature -5°C to +65°C
Storage temperature -20°C to +85°C
Communication interface I2C
1.3 Specifications RFID Tag D6.7 special
Modulation Scheme Close coupling
Dimensions D=6,7mm TH=2,6mm
RFID Protocol ISO 15693
Transmit frequncy 13,56 MHz
Read write type 2kbit EEProm
Operating temperature -15°C to +65°C
Storage temperature -25°C to +125°C
LID Module 1.0

1. General
4
1.4 FCC / IC Compliance
Note:
This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when the equip-
ment is operated in a commercial environment.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instruction manual,
may cause harmful interference to radio com-
munications. Operation of this equipment in a
residential area is likely to cause harmful inter-
ference in which case the user will be required
to correct the interference at his own expense.
!Notice:
This device complies with Part 15 of the FCC
Rules [and with Industry Canada licence-exempt
RSS standard(s)].
Operation is subject to the following two condi-
tions:
1. this device may not cause harmful interfer-
ence, and
2. this device must accept any interference
received, including interference that may
cause undesired operation.
!Notice:
Changes or modifications made to this equipment
not expressly approved by Leica Microsystems
CMS GmbH may void the FCC authorization to op-
erate this equipment.