Leick Home 9206 User manual

Side Frames
Assembly Instructions, #9206
Claudette End Table
---1/2---
Top Frames
Adjustable Shelf
Thank you for purchasing Leick Furniture products.
Contact customer service for comments or concerns.
Sheboygan, WI 800-558-8700 [email protected] todaysdesignhouse.com
Allen Wrench
Flat Washers
Door Pull
Short Bolts
Long Bolts
Machine Screw
Note:
A packet with complete set of hardware can be found by pulling the red ribbon that's
easily visible upon opening the box.
Screws
A
B
C
D
E
F
G
H
I
J
2
1
1
6
8
14
1
1
1
2
Parts List

---2/2---
Step 1 Step 2
Step 3
H
I
J
D
F
E
E
F
A
A
B
C
G
Step 4
D
F
G
F
E
A
B
F
E
G
C
A
B
Put the shelf (C) on with its metal tubes fitted into the side frame's assembly tubes.
Fasten with 2 short bolts and 2 washers.
2.1)
Fasten the top assembly's side panel and back panel to the side frame with 3 long
bolts and washers.
Lay 1 side frame (A) on a soft surface, put the top assembly (B) on, fit the metal
parts into the side frame's tubes.
1.1)
1.2) Fasten the top assembly's front and back bottom edges with 2 short bolts and
washers.
1.3)
Insert tubes of the other side frame to the side of top assembly (B) and shelf (C).
3.1)
Push to make sure all tubes are properly inserted, fasten with 4 short bolts at the
bottom of top assembly and shelf.
3.2)
Fasten the top assembly to the left side frame with 3 long bolts and washers.
3.3)
Place the table upright. For your safety upon doing this process, flip it from the
drawer side to keep from sudden and unintended opening.
4.1)
4.2) Adjust the levelers at the bottom of legs if needed.
4.2) Fasten the drawer pull with 1 machine screw from inner face of drawer front. Check
to ensure the drawer pull is properly aligned before tightening the machine screw.
3.4) Fasten the shelf with 2 screws through the side frame's metal tabs on the bottom.